1 files changed, 94 insertions, 0 deletions
diff --git a/u-boot/board/Marvell/common/bootseq.txt b/u-boot/board/Marvell/common/bootseq.txt
new file mode 100644
index 0000000..e4fefb3
--- /dev/null
+++ b/u-boot/board/Marvell/common/bootseq.txt
@@ -0,0 +1,94 @@
+(cpu/mpc7xxx/start.S)
+
+start:
+    b boot_cold
+
+start_warm:
+    b boot_warm
+
+
+boot_cold:
+boot_warm:
+    clear bats
+    init l2 (if enabled)
+    init altivec (if enabled)
+    invalidate l2 (if enabled)
+    setup bats (from defines in config_EVB)
+    enable_addr_trans: (if MMU enabled)
+	enable MSR_IR and MSR_DR
+    jump to in_flash
+
+in_flash:
+    enable l1 dcache
+    gal_low_init: (board/evb64260/sdram_init.S)
+	config SDRAM (CFG, TIMING, DECODE)
+	init scratch regs (810 + 814)
+
+	detect DIMM0 (bank 0 only)
+	config SDRAM_PARA0 to 256/512Mbit
+	bl sdram_op_mode
+	detect bank0 width
+	    write scratch reg 810
+	config SDRAM_PARA0 with results
+	config SDRAM_PARA1 with results
+
+	detect DIMM1 (bank 2 only)
+	config SDRAM_PARA2 to 256/512Mbit
+	detect bank2 width
+	    write scratch reg 814
+	config SDRAM_PARA2 with results
+	config SDRAM_PARA3 with results
+
+	setup device bus timings/width
+	setup boot device timings/width
+
+	setup CPU_CONF (0x0)
+	setup cpu master control register 0x160
+	setup PCI0 TIMEOUT
+	setup PCI1 TIMEOUT
+	setup PCI0 BAR
+	setup PCI1 BAR
+
+	setup MPP control 0-3
+	setup GPP level control
+	setup Serial ports multiplex
+
+    setup stack pointer (r1)
+    setup GOT
+    call cpu_init_f
+	debug leds
+    board_init_f: (common/board.c)
+	board_early_init_f:
+	    remap gt regs?
+	    map PCI mem/io
+	    map device space
+	    clear out interupts
+	init_timebase
+	env_init
+	serial_init
+	console_init_f
+	display_options
+	initdram: (board/evb64260/evb64260.c)
+	    detect memory
+	    for each bank:
+		dram_size()
+		setup PCI slave memory mappings
+		setup SCS
+	setup monitor
+	alloc board info struct
+	init bd struct
+	relocate_code: (cpu/mpc7xxx/start.S)
+	    copy,got,clearbss
+	    board_init_r(bd, dest_addr) (common/board.c)
+		setup bd function pointers
+		trap_init
+		flash_init: (board/evb64260/flash.c)
+		setup bd flash info
+		cpu_init_r: (cpu/mpc7xxx/cpu_init.c)
+		    nothing
+		mem_malloc_init
+		malloc_bin_reloc
+		spi_init (r or f)??? (CONFIG_ENV_IS_IN_EEPROM)
+		env_relocated
+		misc_init_r(bd): (board/evb64260/evb64260.c)
+		    mpsc_init2