diff options
Diffstat (limited to 'u-boot/board/goldelico/gta04/systest.c')
| -rw-r--r-- | u-boot/board/goldelico/gta04/systest.c | 9 |
1 files changed, 5 insertions, 4 deletions
diff --git a/u-boot/board/goldelico/gta04/systest.c b/u-boot/board/goldelico/gta04/systest.c index 473e9e4..18fde65 100644 --- a/u-boot/board/goldelico/gta04/systest.c +++ b/u-boot/board/goldelico/gta04/systest.c @@ -549,7 +549,7 @@ int irdatest(void) } #ifdef CONFIG_OMAP3_GTA04 -int wlabbtpower(void) +int wlanbtpower(void) { /* Bluetooth VAUX4 = 3.3V -- CHECKME: 3.3 V is not officially supported by TPS! We use 0x09 = 2.8V here*/ #define TCA6507_BUS (2-1) // I2C2 #define TCA6507_ADDRESS 0x45 @@ -564,7 +564,7 @@ int wlabbtpower(void) i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT0, 0); i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT1, 0); i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT2, 0x40); // pull down reset for WLAN&BT chip - i2c_set_bus_num(0); // write I2C1 + i2c_set_bus_num(TWL4030_I2C_BUS); // write I2C1 printf("power on VAUX4\n"); twl4030_pmrecv_vsel_cfg(TWL4030_PM_RECEIVER_VAUX4_DEDICATED, /* 2.8V: */ 0x09 /* 3.15V: 0x0c */, @@ -576,7 +576,7 @@ int wlabbtpower(void) i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT0, 0); i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT1, 0); i2c_reg_write(TCA6507_ADDRESS, TCA6507_SELECT2, 0); // release reset for WLAN&BT chip - i2c_set_bus_num(0); // write I2C1 + i2c_set_bus_num(TWL4030_I2C_BUS); // write I2C1 return 0; } #endif @@ -584,7 +584,7 @@ int wlabbtpower(void) int wlanbttest(int test) { /* Bluetooth VAUX4 = 3.3V -- CHECKME: 3.3 V is not officially supported! We use 0x09 = 2.8V here*/ #ifdef CONFIG_OMAP3_GTA04 - wlabbtpower(); + wlanbtpower(); if(test) { // now, we should be able to test the UART for the BT part... @@ -599,6 +599,7 @@ int wlanbttest(int test) int OTGchargepump(int enable) { + i2c_set_bus_num(TWL4030_I2C_BUS); // I2C1 if(enable) twl4030_i2c_write_u8(TWL4030_CHIP_USB, 0x20, TWL4030_USB_OTG_CTRL_SET); else |