1 files changed, 89 insertions, 0 deletions
diff --git a/u-boot/drivers/gpio/mvmfp.c b/u-boot/drivers/gpio/mvmfp.c
new file mode 100644
index 0000000..e7830c6
--- /dev/null
+++ b/u-boot/drivers/gpio/mvmfp.c
@@ -0,0 +1,89 @@
+/*
+ * (C) Copyright 2010
+ * Marvell Semiconductor <www.marvell.com>
+ * Written-by: Prafulla Wadaskar <prafulla@marvell.com>,
+ *
+ * See file CREDITS for list of people who contributed to this
+ * project.
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of
+ * the License, or (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston,
+ * MA 02110-1301 USA
+ */
+
+#include <common.h>
+#include <asm/io.h>
+#include <mvmfp.h>
+#include <asm/arch/mfp.h>
+#ifdef CONFIG_ARMADA100
+#include <asm/arch/armada100.h>
+#elif defined(CONFIG_PANTHEON)
+#include <asm/arch/pantheon.h>
+#else
+#error Unsupported SoC...
+#endif
+
+/*
+ * mfp_config
+ *
+ * On most of Marvell SoCs (ex. ARMADA100) there is Multi-Funtion-Pin
+ * configuration registers to configure each GPIO/Function pin on the
+ * SoC.
+ *
+ * This function reads the array of values for
+ * MFPR_X registers and programms them into respective
+ * Multi-Function Pin registers.
+ * It supports - Alternate Function Selection programming.
+ *
+ * Whereas,
+ * The Configureation value is constructed using MFP()
+ * array consists of 32bit values as defined in MFP(xx,xx..) macro
+ */
+void mfp_config(u32 *mfp_cfgs)
+{
+	u32 *p_mfpr = NULL;
+	u32 cfg_val, val;
+
+	do {
+		cfg_val = *mfp_cfgs++;
+		/* exit if End of configuration table detected */
+		if (cfg_val == MFP_EOC)
+			break;
+
+		p_mfpr = (u32 *)(MV_MFPR_BASE
+				+ MFP_REG_GET_OFFSET(cfg_val));
+
+		/* Write a mfg register as per configuration */
+		val = 0;
+		if (cfg_val & MFP_AF_FLAG)
+			/* Abstract and program Afternate-Func Selection */
+			val |= cfg_val & MFP_AF_MASK;
+		if (cfg_val & MFP_EDGE_FLAG)
+			/* Abstract and program Edge configuration */
+			val |= cfg_val & MFP_LPM_EDGE_MASK;
+		if (cfg_val & MFP_DRIVE_FLAG)
+			/* Abstract and program Drive configuration */
+			val |= cfg_val & MFP_DRIVE_MASK;
+		if (cfg_val & MFP_PULL_FLAG)
+			/* Abstract and program Pullup/down configuration */
+			val |= cfg_val & MFP_PULL_MASK;
+
+		writel(val, p_mfpr);
+	} while (1);
+	/*
+	 * perform a read-back of any MFPR register to make sure the
+	 * previous writings are finished
+	 */
+	readl(p_mfpr);
+}