// Overload this file in your device specific config if you need // to add extra camera parameters. // A typical file would look like this: /* * Copyright (C) 2014 The CyanogenMod Project * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ /* #define CAMERA_PARAMETERS_EXTRA_C \ const char CameraParameters::KEY_SUPPORTED_BURST_NUM[] = "supported-burst-num"; \ const char CameraParameters::KEY_BURST_NUM[] = "burst-num"; \ const char CameraParameters::KEY_SUPPORTED_HDR_MODES[] = "supported-hdr-modes"; \ const char CameraParameters::KEY_HDR_MODE[] = "hdr-mode"; \ const char CameraParameters::HDR_MODE_OFF[] = "hdr-mode-off"; \ const char CameraParameters::HDR_MODE_HDR[] = "hdr-mode-hdr"; #define CAMERA_PARAMETERS_EXTRA_H \ static const char KEY_SUPPORTED_BURST_NUM[]; \ static const char KEY_BURST_NUM[]; \ static const char KEY_SUPPORTED_HDR_MODES[]; \ static const char KEY_HDR_MODE[]; \ static const char HDR_MODE_OFF[]; \ static const char HDR_MODE_HDR[]; */