diff options
Diffstat (limited to 'Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt')
-rw-r--r-- | Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt | 57 |
1 files changed, 57 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt new file mode 100644 index 0000000..b3aa90f --- /dev/null +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt @@ -0,0 +1,57 @@ +VIA VT8500 and Wondermedia WM8xxx-series pinmux/gpio controller + +These SoCs contain a combined Pinmux/GPIO module. Each pin may operate as +either a GPIO in, GPIO out or as an alternate function (I2C, SPI etc). + +Required properties: +- compatible: "via,vt8500-pinctrl", "wm,wm8505-pinctrl", "wm,wm8650-pinctrl", + "wm8750-pinctrl" or "wm,wm8850-pinctrl" +- reg: Should contain the physical address of the module's registers. +- interrupt-controller: Marks the device node as an interrupt controller. +- #interrupt-cells: Should be two. +- gpio-controller: Marks the device node as a GPIO controller. +- #gpio-cells : Should be two. The first cell is the pin number and the + second cell is used to specify optional parameters. + bit 0 - active low + +Please refer to ../gpio/gpio.txt for a general description of GPIO bindings. + +Please refer to pinctrl-bindings.txt in this directory for details of the +common pinctrl bindings used by client devices, including the meaning of the +phrase "pin configuration node". + +Each pin configuration node lists the pin(s) to which it applies, and one or +more of the mux functions to select on those pin(s), and pull-up/down +configuration. Each subnode only affects those parameters that are explicitly +listed. In other words, a subnode that lists only a mux function implies no +information about any pull configuration. Similarly, a subnode that lists only +a pull parameter implies no information about the mux function. + +Required subnode-properties: +- wm,pins: An array of cells. Each cell contains the ID of a pin. + +Optional subnode-properties: +- wm,function: Integer, containing the function to mux to the pin(s): + 0: GPIO in + 1: GPIO out + 2: alternate + +- wm,pull: Integer, representing the pull-down/up to apply to the pin(s): + 0: none + 1: down + 2: up + +Each of wm,function and wm,pull may contain either a single value which +will be applied to all pins in wm,pins, or one value for each entry in +wm,pins. + +Example: + + pinctrl: pinctrl { + compatible = "wm,wm8505-pinctrl"; + reg = <0xD8110000 0x10000>; + interrupt-controller; + #interrupt-cells = <2>; + gpio-controller; + #gpio-cells = <2>; + }; |