From 9908104935325bd6beba67d637b6f5396d47075c Mon Sep 17 00:00:00 2001 From: Kristian Slavov Date: Wed, 8 Feb 2006 16:10:53 -0800 Subject: [IPV6]: Address autoconfiguration does not work after device down/up cycle If you set network interface down and up again, the IPv6 address autoconfiguration does not work. 'ip addr' shows that the link-local address is in tentative state. We don't even react to periodical router advertisements. During NETDEV_DOWN we clear IF_READY, and we don't set it back in NETDEV_UP. While starting to perform DAD on the link-local address, we notice that the device is not in IF_READY, and we abort autoconfiguration process (which would eventually send router solicitations). Acked-by: Juha-Matti Tapio Acked-by: YOSHIFUJI Hideaki Signed-off-by: David S. Miller --- net/ipv6/addrconf.c | 3 +++ 1 file changed, 3 insertions(+) diff --git a/net/ipv6/addrconf.c b/net/ipv6/addrconf.c index 1db5048..b7d8822 100644 --- a/net/ipv6/addrconf.c +++ b/net/ipv6/addrconf.c @@ -2165,6 +2165,9 @@ static int addrconf_notify(struct notifier_block *this, unsigned long event, dev->name); break; } + + if (idev) + idev->if_flags |= IF_READY; } else { if (!netif_carrier_ok(dev)) { /* device is still not ready. */ -- cgit v1.1