From 9b2c4e0bae854fb5e88c9cacc0dacf21631c5cb0 Mon Sep 17 00:00:00 2001 From: Mark Lord Date: Fri, 2 May 2008 02:09:14 -0400 Subject: sata_mv wait for empty+idle When performing EH, it is recommended to wait for the EDMA engine to empty out requests-in-progress before disabling EDMA. Introduce code to poll the EDMA_STATUS register for idle/empty bits before disabling EDMA. For non-EH operation, this will normally exit without delay, other than the register read. A later series of patches may focus on eliminating this and various other register reads (when possible) throughout the driver, but for now we're focussing on solid reliablity. Signed-off-by: Mark Lord Signed-off-by: Jeff Garzik --- drivers/ata/sata_mv.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+) diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 10ef968..6929962 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -888,6 +888,25 @@ static void mv_start_dma(struct ata_port *ap, void __iomem *port_mmio, } } +static void mv_wait_for_edma_empty_idle(struct ata_port *ap) +{ + void __iomem *port_mmio = mv_ap_base(ap); + const u32 empty_idle = (EDMA_STATUS_CACHE_EMPTY | EDMA_STATUS_IDLE); + const int per_loop = 5, timeout = (15 * 1000 / per_loop); + int i; + + /* + * Wait for the EDMA engine to finish transactions in progress. + */ + for (i = 0; i < timeout; ++i) { + u32 edma_stat = readl(port_mmio + EDMA_STATUS_OFS); + if ((edma_stat & empty_idle) == empty_idle) + break; + udelay(per_loop); + } + /* ata_port_printk(ap, KERN_INFO, "%s: %u+ usecs\n", __func__, i); */ +} + /** * mv_stop_edma_engine - Disable eDMA engine * @port_mmio: io base address @@ -920,6 +939,7 @@ static int mv_stop_edma(struct ata_port *ap) if (!(pp->pp_flags & MV_PP_FLAG_EDMA_EN)) return 0; pp->pp_flags &= ~MV_PP_FLAG_EDMA_EN; + mv_wait_for_edma_empty_idle(ap); if (mv_stop_edma_engine(port_mmio)) { ata_port_printk(ap, KERN_ERR, "Unable to stop eDMA\n"); return -EIO; -- cgit v1.1