From 65a1a0ace554d61ea5a90377a54df1505275c1b1 Mon Sep 17 00:00:00 2001 From: Kenneth Waters Date: Mon, 25 Apr 2011 12:29:54 -0600 Subject: i2c: tegra: Enable new slave mode. For Tegra i2c controller to function properly new slave mode must be enabled. swarren notes: In particular, I found this was needed when working on enabling the Tegra audio driver on the Seaboard board. There are two different PCB layouts for this board; a "clamshell" version, which works just fine without this change, and the original non-clamshell version, which needs this change in order for I2C to operate correctly. Without it, I2C probing fails for some devices, e.g. with: wm8903 0-001a: Device with ID register 0 is not a WM8903 wm8903 0-001a: asoc: failed to probe CODEC wm8903.0-001a: -19 asoc: failed to instantiate card tegra-wm8903: -19 ALSA device list: No soundcards found. Signed-off-by: Rakesh Iyer Cc: stable Signed-off-by: Stephen Warren Signed-off-by: Ben Dooks --- drivers/i2c/busses/i2c-tegra.c | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'drivers/i2c') diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c index b4ab39b..5f1b92c 100644 --- a/drivers/i2c/busses/i2c-tegra.c +++ b/drivers/i2c/busses/i2c-tegra.c @@ -330,6 +330,11 @@ static int tegra_i2c_init(struct tegra_i2c_dev *i2c_dev) i2c_writel(i2c_dev, 0, I2C_INT_MASK); clk_set_rate(i2c_dev->clk, i2c_dev->bus_clk_rate * 8); + if (!i2c_dev->is_dvc) { + u32 sl_cfg = i2c_readl(i2c_dev, I2C_SL_CNFG); + i2c_writel(i2c_dev, sl_cfg | I2C_SL_CNFG_NEWSL, I2C_SL_CNFG); + } + val = 7 << I2C_FIFO_CONTROL_TX_TRIG_SHIFT | 0 << I2C_FIFO_CONTROL_RX_TRIG_SHIFT; i2c_writel(i2c_dev, val, I2C_FIFO_CONTROL); -- cgit v1.1