diff options
Diffstat (limited to 'include/net')
| -rw-r--r-- | include/net/cfg80211.h | 30 | ||||
| -rw-r--r-- | include/net/iw_handler.h | 2 | ||||
| -rw-r--r-- | include/net/mac80211.h | 68 |
3 files changed, 94 insertions, 6 deletions
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h index 3d134a1..37cebd3 100644 --- a/include/net/cfg80211.h +++ b/include/net/cfg80211.h @@ -704,6 +704,10 @@ struct cfg80211_crypto_settings { * @key_len: length of WEP key for shared key authentication * @key_idx: index of WEP key for shared key authentication * @key: WEP key for shared key authentication + * @local_state_change: This is a request for a local state only, i.e., no + * Authentication frame is to be transmitted and authentication state is + * to be changed without having to wait for a response from the peer STA + * (AP). */ struct cfg80211_auth_request { struct cfg80211_bss *bss; @@ -712,6 +716,7 @@ struct cfg80211_auth_request { enum nl80211_auth_type auth_type; const u8 *key; u8 key_len, key_idx; + bool local_state_change; }; /** @@ -744,12 +749,15 @@ struct cfg80211_assoc_request { * @ie: Extra IEs to add to Deauthentication frame or %NULL * @ie_len: Length of ie buffer in octets * @reason_code: The reason code for the deauthentication + * @local_state_change: This is a request for a local state only, i.e., no + * Deauthentication frame is to be transmitted. */ struct cfg80211_deauth_request { struct cfg80211_bss *bss; const u8 *ie; size_t ie_len; u16 reason_code; + bool local_state_change; }; /** @@ -762,12 +770,15 @@ struct cfg80211_deauth_request { * @ie: Extra IEs to add to Disassociation frame or %NULL * @ie_len: Length of ie buffer in octets * @reason_code: The reason code for the disassociation + * @local_state_change: This is a request for a local state only, i.e., no + * Disassociation frame is to be transmitted. */ struct cfg80211_disassoc_request { struct cfg80211_bss *bss; const u8 *ie; size_t ie_len; u16 reason_code; + bool local_state_change; }; /** @@ -1007,6 +1018,7 @@ struct cfg80211_pmksa { * RSN IE. It allows for faster roaming between WPA2 BSSIDs. * @del_pmksa: Delete a cached PMKID. * @flush_pmksa: Flush all cached PMKIDs. + * @set_cqm_rssi_config: Configure connection quality monitor RSSI threshold. * */ struct cfg80211_ops { @@ -1152,6 +1164,10 @@ struct cfg80211_ops { int (*set_power_mgmt)(struct wiphy *wiphy, struct net_device *dev, bool enabled, int timeout); + + int (*set_cqm_rssi_config)(struct wiphy *wiphy, + struct net_device *dev, + s32 rssi_thold, u32 rssi_hyst); }; /* @@ -2337,4 +2353,18 @@ bool cfg80211_rx_action(struct net_device *dev, int freq, const u8 *buf, void cfg80211_action_tx_status(struct net_device *dev, u64 cookie, const u8 *buf, size_t len, bool ack, gfp_t gfp); + +/** + * cfg80211_cqm_rssi_notify - connection quality monitoring rssi event + * @dev: network device + * @rssi_event: the triggered RSSI event + * @gfp: context flags + * + * This function is called when a configured connection quality monitoring + * rssi threshold reached event occurs. + */ +void cfg80211_cqm_rssi_notify(struct net_device *dev, + enum nl80211_cqm_rssi_threshold_event rssi_event, + gfp_t gfp); + #endif /* __NET_CFG80211_H */ diff --git a/include/net/iw_handler.h b/include/net/iw_handler.h index b2b98f3..3afdb21 100644 --- a/include/net/iw_handler.h +++ b/include/net/iw_handler.h @@ -323,7 +323,7 @@ typedef int (*iw_handler)(struct net_device *dev, struct iw_request_info *info, struct iw_handler_def { /* Array of handlers for standard ioctls - * We will call dev->wireless_handlers->standard[ioctl - SIOCSIWCOMMIT] + * We will call dev->wireless_handlers->standard[ioctl - SIOCIWFIRST] */ const iw_handler * standard; /* Number of handlers defined (more precisely, index of the diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 45d7d44..dcf3c5f 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -144,6 +144,7 @@ struct ieee80211_low_level_stats { * new beacon (beaconing modes) * @BSS_CHANGED_BEACON_ENABLED: Beaconing should be * enabled/disabled (beaconing modes) + * @BSS_CHANGED_CQM: Connection quality monitor config changed */ enum ieee80211_bss_change { BSS_CHANGED_ASSOC = 1<<0, @@ -156,6 +157,7 @@ enum ieee80211_bss_change { BSS_CHANGED_BSSID = 1<<7, BSS_CHANGED_BEACON = 1<<8, BSS_CHANGED_BEACON_ENABLED = 1<<9, + BSS_CHANGED_CQM = 1<<10, }; /** @@ -185,6 +187,9 @@ enum ieee80211_bss_change { * @enable_beacon: whether beaconing should be enabled or not * @ht_operation_mode: HT operation mode (like in &struct ieee80211_ht_info). * This field is only valid when the channel type is one of the HT types. + * @cqm_rssi_thold: Connection quality monitor RSSI threshold, a zero value + * implies disabled + * @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis */ struct ieee80211_bss_conf { const u8 *bssid; @@ -202,6 +207,8 @@ struct ieee80211_bss_conf { u64 timestamp; u32 basic_rates; u16 ht_operation_mode; + s32 cqm_rssi_thold; + u32 cqm_rssi_hyst; }; /** @@ -543,7 +550,7 @@ enum mac80211_rx_flags { * @signal: signal strength when receiving this frame, either in dBm, in dB or * unspecified depending on the hardware capabilities flags * @IEEE80211_HW_SIGNAL_* - * @noise: noise when receiving this frame, in dBm. + * @noise: noise when receiving this frame, in dBm (DEPRECATED). * @antenna: antenna used * @rate_idx: index of data rate into band's supported rates or MCS index if * HT rates are use (RX_FLAG_HT) @@ -554,7 +561,7 @@ struct ieee80211_rx_status { enum ieee80211_band band; int freq; int signal; - int noise; + int noise __deprecated; int antenna; int rate_idx; int flag; @@ -580,11 +587,15 @@ struct ieee80211_rx_status { * may turn the device off as much as possible. Typically, this flag will * be set when an interface is set UP but not associated or scanning, but * it can also be unset in that case when monitor interfaces are active. + * @IEEE80211_CONF_QOS: Enable 802.11e QoS also know as WMM (Wireless + * Multimedia). On some drivers (iwlwifi is one of know) we have + * to enable/disable QoS explicitly. */ enum ieee80211_conf_flags { IEEE80211_CONF_MONITOR = (1<<0), IEEE80211_CONF_PS = (1<<1), IEEE80211_CONF_IDLE = (1<<2), + IEEE80211_CONF_QOS = (1<<3), }; @@ -609,6 +620,7 @@ enum ieee80211_conf_changed { IEEE80211_CONF_CHANGE_CHANNEL = BIT(6), IEEE80211_CONF_CHANGE_RETRY_LIMITS = BIT(7), IEEE80211_CONF_CHANGE_IDLE = BIT(8), + IEEE80211_CONF_CHANGE_QOS = BIT(9), }; /** @@ -954,6 +966,17 @@ enum ieee80211_tkip_key_type { * Hardware can provide ack status reports of Tx frames to * the stack. * + * @IEEE80211_HW_CONNECTION_MONITOR: + * The hardware performs its own connection monitoring, including + * periodic keep-alives to the AP and probing the AP on beacon loss. + * When this flag is set, signaling beacon-loss will cause an immediate + * change to disassociated state. + * + * @IEEE80211_HW_SUPPORTS_CQM_RSSI: + * Hardware can do connection quality monitoring - i.e. it can monitor + * connection quality related parameters, such as the RSSI level and + * provide notifications if configured trigger levels are reached. + * */ enum ieee80211_hw_flags { IEEE80211_HW_HAS_RATE_CONTROL = 1<<0, @@ -975,6 +998,8 @@ enum ieee80211_hw_flags { IEEE80211_HW_SUPPORTS_DYNAMIC_SMPS = 1<<16, IEEE80211_HW_SUPPORTS_UAPSD = 1<<17, IEEE80211_HW_REPORTS_TX_ACK_STATUS = 1<<18, + IEEE80211_HW_CONNECTION_MONITOR = 1<<19, + IEEE80211_HW_SUPPORTS_CQM_RSSI = 1<<20, }; /** @@ -1802,7 +1827,10 @@ void ieee80211_restart_hw(struct ieee80211_hw *hw); * ieee80211_rx - receive frame * * Use this function to hand received frames to mac80211. The receive - * buffer in @skb must start with an IEEE 802.11 header. + * buffer in @skb must start with an IEEE 802.11 header. In case of a + * paged @skb is used, the driver is recommended to put the ieee80211 + * header of the frame on the linear part of the @skb to avoid memory + * allocation and/or memcpy by the stack. * * This function may not be called in IRQ context. Calls to this function * for a single hardware must be synchronized against each other. Calls to @@ -2364,12 +2392,42 @@ void ieee80211_sta_block_awake(struct ieee80211_hw *hw, * * @vif: &struct ieee80211_vif pointer from the add_interface callback. * - * When beacon filtering is enabled with IEEE80211_HW_BEACON_FILTERING and - * IEEE80211_CONF_PS is set, the driver needs to inform whenever the + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING and + * %IEEE80211_CONF_PS is set, the driver needs to inform whenever the * hardware is not receiving beacons with this function. */ void ieee80211_beacon_loss(struct ieee80211_vif *vif); +/** + * ieee80211_connection_loss - inform hardware has lost connection to the AP + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING, and + * %IEEE80211_CONF_PS and %IEEE80211_HW_CONNECTION_MONITOR are set, the driver + * needs to inform if the connection to the AP has been lost. + * + * This function will cause immediate change to disassociated state, + * without connection recovery attempts. + */ +void ieee80211_connection_loss(struct ieee80211_vif *vif); + +/** + * ieee80211_cqm_rssi_notify - inform a configured connection quality monitoring + * rssi threshold triggered + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * @rssi_event: the RSSI trigger event type + * @gfp: context flags + * + * When the %IEEE80211_HW_SUPPORTS_CQM_RSSI is set, and a connection quality + * monitoring is configured with an rssi threshold, the driver will inform + * whenever the rssi level reaches the threshold. + */ +void ieee80211_cqm_rssi_notify(struct ieee80211_vif *vif, + enum nl80211_cqm_rssi_threshold_event rssi_event, + gfp_t gfp); + /* Rate control API */ /** |