From b97752edef4b90090346427bd50172b6f4c1ebde Mon Sep 17 00:00:00 2001 From: Bruno Randolf Date: Thu, 7 Mar 2013 16:45:17 +0000 Subject: bcmdhd: Enable Ad-Hoc (IBSS) mode Enable Ad-Hoc (IBSS) mode for bcmdhd. We basically just need to set the interface flag and avoid some P2P specific settings while scanning. Also add the "station get" command for IBSS mode. Change-Id: Ice320bc65b0b9b738fa09acc1e3dea2a58805ad9 Signed-off-by: Bruno Randolf --- drivers/net/wireless/bcmdhd/wl_cfg80211.c | 65 ++++++++++++++++++++++++++++++- 1 file changed, 63 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/bcmdhd/wl_cfg80211.c b/drivers/net/wireless/bcmdhd/wl_cfg80211.c index 3b9ca46..30e7006 100644 --- a/drivers/net/wireless/bcmdhd/wl_cfg80211.c +++ b/drivers/net/wireless/bcmdhd/wl_cfg80211.c @@ -1616,7 +1616,7 @@ __wl_cfg80211_scan(struct wiphy *wiphy, struct net_device *ndev, WL_DBG(("P2P: GO_NEG_PHASE status cleared \n")); p2p_scan(wl) = true; } - } else { + } else if (wl_get_mode_by_netdev(wl, ndev) != WL_MODE_IBSS) { /* legacy scan trigger * So, we have to disable p2p discovery if p2p discovery is on */ @@ -3068,7 +3068,68 @@ get_station_err: wl_link_down(wl); } } + else if (wl_get_mode_by_netdev(wl, dev) == WL_MODE_IBSS) { + u8 *curmacp = wl_read_prof(wl, dev, WL_PROF_BSSID); + + memset(&scb_val, 0, sizeof(scb_val)); + bcopy(mac, &scb_val.ea, 6); + + err = wldev_ioctl(dev, WLC_GET_RSSI, &scb_val, + sizeof(scb_val_t), false); + if (err) { + WL_ERR(("Could not get rssi (%d)\n", err)); + return err; + } + rssi = dtoh32(scb_val.val); + + /* the RSSI value from the firmware is an average but user-space + expects it as signal, so we fill in both */ + sinfo->filled |= STATION_INFO_SIGNAL; + sinfo->signal = rssi; + sinfo->filled |= STATION_INFO_SIGNAL_AVG; + sinfo->signal_avg = rssi; + + if (!memcmp(mac, curmacp, ETHER_ADDR_LEN)) { + // BSSID is not a real station. Can't get sta_info; Done + return 0; + } + err = wldev_iovar_getbuf(dev, "sta_info", (struct ether_addr *)mac, + ETHER_ADDR_LEN, wl->ioctl_buf, WLC_IOCTL_MAXLEN, &wl->ioctl_buf_sync); + if (err < 0) { + WL_ERR(("GET STA INFO failed, %d\n", err)); + return err; + } + + sta = (sta_info_t *)wl->ioctl_buf; + sta->len = dtoh16(sta->len); + sta->cap = dtoh16(sta->cap); + sta->flags = dtoh32(sta->flags); + sta->idle = dtoh32(sta->idle); + sta->in = dtoh32(sta->in); + sta->listen_interval_inms = dtoh32(sta->listen_interval_inms); + sta->tx_pkts = dtoh32(sta->tx_pkts); + sta->tx_failures = dtoh32(sta->tx_failures); + sta->rx_ucast_pkts = dtoh32(sta->rx_ucast_pkts); + sta->rx_mcast_pkts = dtoh32(sta->rx_mcast_pkts); + sta->tx_rate = dtoh32(sta->tx_rate); + sta->rx_rate = dtoh32(sta->rx_rate); + sta->rx_decrypt_succeeds = dtoh32(sta->rx_decrypt_succeeds); + sta->rx_decrypt_failures = dtoh32(sta->rx_decrypt_failures); + + sinfo->filled |= STATION_INFO_INACTIVE_TIME | STATION_INFO_TX_PACKETS | + STATION_INFO_TX_FAILED | STATION_INFO_RX_PACKETS | + STATION_INFO_TX_BITRATE | STATION_INFO_RX_BITRATE | + STATION_INFO_RX_DROP_MISC; + + sinfo->inactive_time = sta->idle * 1000; + sinfo->tx_packets = sta->tx_pkts; + sinfo->tx_failed = sta->tx_failures; + sinfo->rx_packets = sta->rx_ucast_pkts + sta->rx_mcast_pkts; + sinfo->txrate.legacy = sta->tx_rate / 100; + sinfo->rxrate.legacy = sta->rx_rate / 100; + sinfo->rx_dropped_misc = sta->rx_decrypt_failures; + } return err; } @@ -4653,7 +4714,7 @@ static s32 wl_setup_wiphy(struct wireless_dev *wdev, struct device *sdiofunc_dev wdev->wiphy->flags |= WIPHY_FLAG_SUPPORTS_SCHED_SCAN; #endif /* WL_SCHED_SCAN */ wdev->wiphy->interface_modes = - BIT(NL80211_IFTYPE_STATION) + BIT(NL80211_IFTYPE_STATION) | BIT(NL80211_IFTYPE_ADHOC) | BIT(NL80211_IFTYPE_AP) | BIT(NL80211_IFTYPE_MONITOR); wdev->wiphy->bands[IEEE80211_BAND_2GHZ] = &__wl_band_2ghz; -- cgit v1.1