diff options
Diffstat (limited to 'drivers/net/e1000e/82571.c')
| -rw-r--r-- | drivers/net/e1000e/82571.c | 116 |
1 files changed, 84 insertions, 32 deletions
diff --git a/drivers/net/e1000e/82571.c b/drivers/net/e1000e/82571.c index 62bbc6e..c1a42cf 100644 --- a/drivers/net/e1000e/82571.c +++ b/drivers/net/e1000e/82571.c @@ -65,9 +65,11 @@ static s32 e1000_fix_nvm_checksum_82571(struct e1000_hw *hw); static void e1000_initialize_hw_bits_82571(struct e1000_hw *hw); static s32 e1000_setup_link_82571(struct e1000_hw *hw); static void e1000_clear_hw_cntrs_82571(struct e1000_hw *hw); +static void e1000_clear_vfta_82571(struct e1000_hw *hw); static bool e1000_check_mng_mode_82574(struct e1000_hw *hw); static s32 e1000_led_on_82574(struct e1000_hw *hw); static void e1000_put_hw_semaphore_82571(struct e1000_hw *hw); +static void e1000_power_down_phy_copper_82571(struct e1000_hw *hw); /** * e1000_init_phy_params_82571 - Init PHY func ptrs. @@ -87,6 +89,9 @@ static s32 e1000_init_phy_params_82571(struct e1000_hw *hw) phy->autoneg_mask = AUTONEG_ADVERTISE_SPEED_DEFAULT; phy->reset_delay_us = 100; + phy->ops.power_up = e1000_power_up_phy_copper; + phy->ops.power_down = e1000_power_down_phy_copper_82571; + switch (hw->mac.type) { case e1000_82571: case e1000_82572: @@ -949,7 +954,7 @@ static s32 e1000_init_hw_82571(struct e1000_hw *hw) /* Disabling VLAN filtering */ e_dbg("Initializing the IEEE VLAN\n"); - e1000e_clear_vfta(hw); + mac->ops.clear_vfta(hw); /* Setup the receive address. */ /* @@ -1128,13 +1133,13 @@ static void e1000_initialize_hw_bits_82571(struct e1000_hw *hw) } /** - * e1000e_clear_vfta - Clear VLAN filter table + * e1000_clear_vfta_82571 - Clear VLAN filter table * @hw: pointer to the HW structure * * Clears the register array which contains the VLAN filter table by * setting all the values to 0. **/ -void e1000e_clear_vfta(struct e1000_hw *hw) +static void e1000_clear_vfta_82571(struct e1000_hw *hw) { u32 offset; u32 vfta_value = 0; @@ -1351,8 +1356,20 @@ static s32 e1000_setup_fiber_serdes_link_82571(struct e1000_hw *hw) * e1000_check_for_serdes_link_82571 - Check for link (Serdes) * @hw: pointer to the HW structure * - * Checks for link up on the hardware. If link is not up and we have - * a signal, then we need to force link up. + * Reports the link state as up or down. + * + * If autonegotiation is supported by the link partner, the link state is + * determined by the result of autonegotiation. This is the most likely case. + * If autonegotiation is not supported by the link partner, and the link + * has a valid signal, force the link up. + * + * The link state is represented internally here by 4 states: + * + * 1) down + * 2) autoneg_progress + * 3) autoneg_complete (the link sucessfully autonegotiated) + * 4) forced_up (the link has been forced up, it did not autonegotiate) + * **/ static s32 e1000_check_for_serdes_link_82571(struct e1000_hw *hw) { @@ -1378,6 +1395,7 @@ static s32 e1000_check_for_serdes_link_82571(struct e1000_hw *hw) */ mac->serdes_link_state = e1000_serdes_link_autoneg_progress; + mac->serdes_has_link = false; e_dbg("AN_UP -> AN_PROG\n"); } break; @@ -1392,57 +1410,64 @@ static s32 e1000_check_for_serdes_link_82571(struct e1000_hw *hw) if (rxcw & E1000_RXCW_C) { /* Enable autoneg, and unforce link up */ ew32(TXCW, mac->txcw); - ew32(CTRL, - (ctrl & ~E1000_CTRL_SLU)); + ew32(CTRL, (ctrl & ~E1000_CTRL_SLU)); mac->serdes_link_state = e1000_serdes_link_autoneg_progress; + mac->serdes_has_link = false; e_dbg("FORCED_UP -> AN_PROG\n"); } break; case e1000_serdes_link_autoneg_progress: - /* - * If the LU bit is set in the STATUS register, - * autoneg has completed sucessfully. If not, - * try foring the link because the far end may be - * available but not capable of autonegotiation. - */ - if (status & E1000_STATUS_LU) { - mac->serdes_link_state = - e1000_serdes_link_autoneg_complete; - e_dbg("AN_PROG -> AN_UP\n"); + if (rxcw & E1000_RXCW_C) { + /* + * We received /C/ ordered sets, meaning the + * link partner has autonegotiated, and we can + * trust the Link Up (LU) status bit. + */ + if (status & E1000_STATUS_LU) { + mac->serdes_link_state = + e1000_serdes_link_autoneg_complete; + e_dbg("AN_PROG -> AN_UP\n"); + mac->serdes_has_link = true; + } else { + /* Autoneg completed, but failed. */ + mac->serdes_link_state = + e1000_serdes_link_down; + e_dbg("AN_PROG -> DOWN\n"); + } } else { /* - * Disable autoneg, force link up and - * full duplex, and change state to forced + * The link partner did not autoneg. + * Force link up and full duplex, and change + * state to forced. */ - ew32(TXCW, - (mac->txcw & ~E1000_TXCW_ANE)); + ew32(TXCW, (mac->txcw & ~E1000_TXCW_ANE)); ctrl |= (E1000_CTRL_SLU | E1000_CTRL_FD); ew32(CTRL, ctrl); /* Configure Flow Control after link up. */ - ret_val = - e1000e_config_fc_after_link_up(hw); + ret_val = e1000e_config_fc_after_link_up(hw); if (ret_val) { e_dbg("Error config flow control\n"); break; } mac->serdes_link_state = e1000_serdes_link_forced_up; + mac->serdes_has_link = true; e_dbg("AN_PROG -> FORCED_UP\n"); } - mac->serdes_has_link = true; break; case e1000_serdes_link_down: default: - /* The link was down but the receiver has now gained + /* + * The link was down but the receiver has now gained * valid sync, so lets see if we can bring the link - * up. */ + * up. + */ ew32(TXCW, mac->txcw); - ew32(CTRL, - (ctrl & ~E1000_CTRL_SLU)); + ew32(CTRL, (ctrl & ~E1000_CTRL_SLU)); mac->serdes_link_state = e1000_serdes_link_autoneg_progress; e_dbg("DOWN -> AN_PROG\n"); @@ -1455,9 +1480,9 @@ static s32 e1000_check_for_serdes_link_82571(struct e1000_hw *hw) e_dbg("ANYSTATE -> DOWN\n"); } else { /* - * We have sync, and can tolerate one - * invalid (IV) codeword before declaring - * link down, so reread to look again + * We have sync, and can tolerate one invalid (IV) + * codeword before declaring link down, so reread + * to look again. */ udelay(10); rxcw = er32(RXCW); @@ -1526,7 +1551,7 @@ bool e1000e_get_laa_state_82571(struct e1000_hw *hw) * @hw: pointer to the HW structure * @state: enable/disable locally administered address * - * Enable/Disable the current locally administers address state. + * Enable/Disable the current locally administered address state. **/ void e1000e_set_laa_state_82571(struct e1000_hw *hw, bool state) { @@ -1600,6 +1625,28 @@ static s32 e1000_fix_nvm_checksum_82571(struct e1000_hw *hw) } /** + * e1000_power_down_phy_copper_82571 - Remove link during PHY power down + * @hw: pointer to the HW structure + * + * In the case of a PHY power down to save power, or to turn off link during a + * driver unload, or wake on lan is not enabled, remove the link. + **/ +static void e1000_power_down_phy_copper_82571(struct e1000_hw *hw) +{ + struct e1000_phy_info *phy = &hw->phy; + struct e1000_mac_info *mac = &hw->mac; + + if (!(phy->ops.check_reset_block)) + return; + + /* If the management interface is not enabled, then power down */ + if (!(mac->ops.check_mng_mode(hw) || phy->ops.check_reset_block(hw))) + e1000_power_down_phy_copper(hw); + + return; +} + +/** * e1000_clear_hw_cntrs_82571 - Clear device specific hardware counters * @hw: pointer to the HW structure * @@ -1656,6 +1703,8 @@ static struct e1000_mac_operations e82571_mac_ops = { /* .led_on: mac type dependent */ .led_off = e1000e_led_off_generic, .update_mc_addr_list = e1000_update_mc_addr_list_82571, + .write_vfta = e1000_write_vfta_generic, + .clear_vfta = e1000_clear_vfta_82571, .reset_hw = e1000_reset_hw_82571, .init_hw = e1000_init_hw_82571, .setup_link = e1000_setup_link_82571, @@ -1665,6 +1714,7 @@ static struct e1000_mac_operations e82571_mac_ops = { static struct e1000_phy_operations e82_phy_ops_igp = { .acquire = e1000_get_hw_semaphore_82571, + .check_polarity = e1000_check_polarity_igp, .check_reset_block = e1000e_check_reset_block_generic, .commit = NULL, .force_speed_duplex = e1000e_phy_force_speed_duplex_igp, @@ -1682,6 +1732,7 @@ static struct e1000_phy_operations e82_phy_ops_igp = { static struct e1000_phy_operations e82_phy_ops_m88 = { .acquire = e1000_get_hw_semaphore_82571, + .check_polarity = e1000_check_polarity_m88, .check_reset_block = e1000e_check_reset_block_generic, .commit = e1000e_phy_sw_reset, .force_speed_duplex = e1000e_phy_force_speed_duplex_m88, @@ -1699,6 +1750,7 @@ static struct e1000_phy_operations e82_phy_ops_m88 = { static struct e1000_phy_operations e82_phy_ops_bm = { .acquire = e1000_get_hw_semaphore_82571, + .check_polarity = e1000_check_polarity_m88, .check_reset_block = e1000e_check_reset_block_generic, .commit = e1000e_phy_sw_reset, .force_speed_duplex = e1000e_phy_force_speed_duplex_m88, |