diff options
Diffstat (limited to 'Documentation/arm')
| -rw-r--r-- | Documentation/arm/OMAP/DSS | 46 |
1 files changed, 46 insertions, 0 deletions
diff --git a/Documentation/arm/OMAP/DSS b/Documentation/arm/OMAP/DSS index 888ae7b..a564cee 100644 --- a/Documentation/arm/OMAP/DSS +++ b/Documentation/arm/OMAP/DSS @@ -47,6 +47,51 @@ flexible way to enable non-common multi-display configuration. In addition to modelling the hardware overlays, omapdss supports virtual overlays and overlay managers. These can be used when updating a display with CPU or system DMA. +omapdss driver support for audio +-------------------------------- +There exist several display technologies and standards that support audio as +well. Hence, it is relevant to update the DSS device driver to provide an audio +interface that may be used by an audio driver or any other driver interested in +the functionality. + +The audio_enable function is intended to prepare the relevant +IP for playback (e.g., enabling an audio FIFO, taking in/out of reset +some IP, enabling companion chips, etc). It is intended to be called before +audio_start. The audio_disable function performs the reverse operation and is +intended to be called after audio_stop. + +While a given DSS device driver may support audio, it is possible that for +certain configurations audio is not supported (e.g., an HDMI display using a +VESA video timing). The audio_supported function is intended to query whether +the current configuration of the display supports audio. + +The audio_config function is intended to configure all the relevant audio +parameters of the display. In order to make the function independent of any +specific DSS device driver, a struct omap_dss_audio is defined. Its purpose +is to contain all the required parameters for audio configuration. At the +moment, such structure contains pointers to IEC-60958 channel status word +and CEA-861 audio infoframe structures. This should be enough to support +HDMI and DisplayPort, as both are based on CEA-861 and IEC-60958. + +The audio_enable/disable, audio_config and audio_supported functions could be +implemented as functions that may sleep. Hence, they should not be called +while holding a spinlock or a readlock. + +The audio_start/audio_stop function is intended to effectively start/stop audio +playback after the configuration has taken place. These functions are designed +to be used in an atomic context. Hence, audio_start should return quickly and be +called only after all the needed resources for audio playback (audio FIFOs, +DMA channels, companion chips, etc) have been enabled to begin data transfers. +audio_stop is designed to only stop the audio transfers. The resources used +for playback are released using audio_disable. + +The enum omap_dss_audio_state may be used to help the implementations of +the interface to keep track of the audio state. The initial state is _DISABLED; +then, the state transitions to _CONFIGURED, and then, when it is ready to +play audio, to _ENABLED. The state _PLAYING is used when the audio is being +rendered. + + Panel and controller drivers ---------------------------- @@ -156,6 +201,7 @@ timings Display timings (pixclock,xres/hfp/hbp/hsw,yres/vfp/vbp/vsw) "pal" and "ntsc" panel_name tear_elim Tearing elimination 0=off, 1=on +output_type Output type (video encoder only): "composite" or "svideo" There are also some debugfs files at <debugfs>/omapdss/ which show information about clocks and registers. |