diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mtd/gpmc-nor.txt')
-rw-r--r-- | Documentation/devicetree/bindings/mtd/gpmc-nor.txt | 98 |
1 files changed, 98 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt new file mode 100644 index 0000000..420b3ab --- /dev/null +++ b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt @@ -0,0 +1,98 @@ +Device tree bindings for NOR flash connect to TI GPMC + +NOR flash connected to the TI GPMC (found on OMAP boards) are represented as +child nodes of the GPMC controller with a name of "nor". + +All timing relevant properties as well as generic GPMC child properties are +explained in a separate documents. Please refer to +Documentation/devicetree/bindings/bus/ti-gpmc.txt + +Required properties: +- bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and + 16-bit devices and so must be either 1 or 2 bytes. +- compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.txt +- gpmc,cs-on-ns: Chip-select assertion time +- gpmc,cs-rd-off-ns: Chip-select de-assertion time for reads +- gpmc,cs-wr-off-ns: Chip-select de-assertion time for writes +- gpmc,oe-on-ns: Output-enable assertion time +- gpmc,oe-off-ns: Output-enable de-assertion time +- gpmc,we-on-ns Write-enable assertion time +- gpmc,we-off-ns: Write-enable de-assertion time +- gpmc,access-ns: Start cycle to first data capture (read access) +- gpmc,rd-cycle-ns: Total read cycle time +- gpmc,wr-cycle-ns: Total write cycle time +- linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.txt +- reg: Chip-select, base address (relative to chip-select) + and size of NOR flash. Note that base address will be + typically 0 as this is the start of the chip-select. + +Optional properties: +- gpmc,XXX Additional GPMC timings and settings parameters. See + Documentation/devicetree/bindings/bus/ti-gpmc.txt + +Optional properties for partiton table parsing: +- #address-cells: should be set to 1 +- #size-cells: should be set to 1 + +Example: + +gpmc: gpmc@6e000000 { + compatible = "ti,omap3430-gpmc", "simple-bus"; + ti,hwmods = "gpmc"; + reg = <0x6e000000 0x1000>; + interrupts = <20>; + gpmc,num-cs = <8>; + gpmc,num-waitpins = <4>; + #address-cells = <2>; + #size-cells = <1>; + + ranges = <0 0 0x10000000 0x08000000>; + + nor@0,0 { + compatible = "cfi-flash"; + linux,mtd-name= "intel,pf48f6000m0y1be"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0 0 0x08000000>; + bank-width = <2>; + + gpmc,mux-add-data; + gpmc,cs-on-ns = <0>; + gpmc,cs-rd-off-ns = <186>; + gpmc,cs-wr-off-ns = <186>; + gpmc,adv-on-ns = <12>; + gpmc,adv-rd-off-ns = <48>; + gpmc,adv-wr-off-ns = <48>; + gpmc,oe-on-ns = <54>; + gpmc,oe-off-ns = <168>; + gpmc,we-on-ns = <54>; + gpmc,we-off-ns = <168>; + gpmc,rd-cycle-ns = <186>; + gpmc,wr-cycle-ns = <186>; + gpmc,access-ns = <114>; + gpmc,page-burst-access-ns = <6>; + gpmc,bus-turnaround-ns = <12>; + gpmc,cycle2cycle-delay-ns = <18>; + gpmc,wr-data-mux-bus-ns = <90>; + gpmc,wr-access-ns = <186>; + gpmc,cycle2cycle-samecsen; + gpmc,cycle2cycle-diffcsen; + + partition@0 { + label = "bootloader-nor"; + reg = <0 0x40000>; + }; + partition@0x40000 { + label = "params-nor"; + reg = <0x40000 0x40000>; + }; + partition@0x80000 { + label = "kernel-nor"; + reg = <0x80000 0x200000>; + }; + partition@0x280000 { + label = "filesystem-nor"; + reg = <0x240000 0x7d80000>; + }; + }; +}; |