aboutsummaryrefslogtreecommitdiffstats
path: root/arch/arm/mach-shmobile/board-lager.c
Commit message (Collapse)AuthorAgeFilesLines
* ARM: shmobile: Lager: add Micrel KSZ8041 PHY fixupSergei Shtylyov2013-09-211-1/+26
| | | | | | | | | | | | | | | Currently on the Lager board NFS timeouts/delays are seen when booting. That turned out to happen because the SoC's ETH_LINK signal turns on and off after each packet. It is connected to Micrel KSZ8041 PHY's LED0 signal. Ether LEDs on the Lager board are named LINK and ACTIVE which corresponds to non-default 01 setting of the PHY control register 1 bits 14-15. The 'sh_eth' driver resets the PHY when opening the network device, so we have to set the mentioned bits back to 01 from the default 00 value which causes bouncing of ETH_LINK. That can be achieved using the PHY platform fixup mechanism if we also modify the driver to use it.. Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: lager: Do not use register_type field of struct sh_eth_plat_dataSimon Horman2013-09-091-1/+0
| | | | | | | | | | As of 8d3214c ("sh_eth: remove 'register_type' field from 'struct sh_eth_plat_data'") is is no longer necessary or correct to use the 'register_type' field from 'struct sh_eth_plat_data' and doing so results in a build error. Signed-off-by: Simon Horman <horms+renesas@verge.net.au> Signed-off-by: Olof Johansson <olof@lixom.net>
* Merge tag 'boards-for-linus' of ↵Linus Torvalds2013-09-061-0/+60
|\ | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc Pull ARM SoC board updates from Olof Johansson: "Board updates for 3.12. Again, a bit of domain overlap with SoC and DT branches, but most of this is around legacy code and board support. We've found that platform maintainers have a hard time separating all of these out and might move towards fewer branches for next release. - Removal of a number of Marvell Kirkwood board files, since contents is now common and mostly configured via DT. - Device-tree updates for Marvell Dove, including irqchip and clocksource setup. - Defconfig updates. Gotta go somewhere. One new one for Renesas Lager. - New backlight drivers for backlights used on Renesas shmobile platforms. - Removal of Renesas leds driver. - Shuffling of some of the new Broadcom platforms to give room for others in the same mach directory. More in 3.13" * tag 'boards-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (67 commits) mmc: sdhci-bcm-kona: Staticize sdhci_bcm_kona_card_event mmc: sdhci-bcm-kona: Remove unneeded version.h inclusion ARM: bcm: Make secure API call optional ARM: DT: binding fixup to align with vendor-prefixes.txt (drivers) ARM: mmc: fix NONREMOVABLE test in sdhci-bcm-kona ARM: bcm: Rename board_bcm mmc: sdhci-bcm-kona: make linker-section warning go away ARM: tegra: defconfig updates ARM: dove: add initial DT file for Globalscale D2Plug ARM: dove: add GPIO IR receiver node to SolidRun CuBox ARM: dove: add common pinmux functions to DT ARM: dove: add cpu device tree node ARM: dove: update dove_defconfig with SI5351, PCI, and xHCI arch/arm/mach-kirkwood: Avoid using ARRAY_AND_SIZE(e) as a function argument ARM: kirkwood: fix DT building and update defconfig ARM: kirkwood: Remove all remaining trace of DNS-320/325 platform code ARM: configs: disable DEBUG_LL in bcm_defconfig ARM: bcm281xx: Board specific reboot code ARM bcm281xx: Turn on socket & network support. ARM: bcm281xx: Turn on L2 cache. ...
| * Merge tag 'renesas-boards-cleanup-for-v3.12' of ↵Olof Johansson2013-08-141-2/+2
| |\ | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas into next/boards From Simon Horman: Renesas ARM based SoC boards cleanups for v3.12 * Add __initdata annotations to lager board * Add __initconst annotations to ape6evm board * tag 'renesas-boards-cleanup-for-v3.12' of git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas: ARM: shmobile: lager: add missing __initdata ARM: shmobile: ape6evm: add "__initconst" annotations where needed Signed-off-by: Olof Johansson <olof@lixom.net>
| | * ARM: shmobile: lager: add missing __initdataKuninori Morimoto2013-08-061-2/+2
| | | | | | | | | | | | | | | | | | | | | | | | This patch adds missing __initdata to driver data/resource which are used from platform_device_register_xxx() Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
| * | ARM: shmobile: lager: enable EtherSimon Horman2013-08-061-0/+29
| |/ | | | | | | | | Acked-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
| * ARM: shmobile: lager: add MMCIF supportGuennadi Liakhovetski2013-07-171-0/+31
| | | | | | | | | | | | | | Add support for the MMCIF1 interface on Lager. Signed-off-by: Guennadi Liakhovetski <g.liakhovetski+renesas@gmail.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* | Merge tag 'omap-for-v3.12/dra7xx' of ↵Kevin Hilman2013-08-191-1/+1
|\ \ | |/ |/| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into next/soc From Tony Lindgren: Minimal DRA7xx based SoC core support via Rajendra Nayak <rnayak@ti.com> * tag 'omap-for-v3.12/dra7xx' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: (849 commits) ARM: DRA7: Add the build support in omap2plus ARM: DRA7: hwmod: Reuse the soc_ops used for OMAP4/5 ARM: DRA7: id: Add cpu detection support for DRA7xx based SoCs' ARM: DRA7: Kconfig: Make ARCH_NR_GPIO default to 512 ARM: DRA7: board-generic: Add basic DT support ARM: DRA7: Resue the clocksource, clockevent support ARM: DRA7: Reuse io tables and add a new .init_early ARM: DRA7: Reuse all of PRCM and MPUSS SMP infra Linux 3.11-rc5 btrfs: don't loop on large offsets in readdir Btrfs: check to see if root_list is empty before adding it to dead roots Btrfs: release both paths before logging dir/changed extents Btrfs: allow splitting of hole em's when dropping extent cache Btrfs: make sure the backref walker catches all refs to our extent Btrfs: fix backref walking when we hit a compressed extent Btrfs: do not offset physical if we're compressed Btrfs: fix extent buffer leak after backref walking Btrfs: fix a bug of snapshot-aware defrag to make it work on partial extents btrfs: fix file truncation if FALLOC_FL_KEEP_SIZE is specified dlm: kill the unnecessary and wrong device_close()->recalc_sigpending() ... Signed-off-by: Kevin Hilman <khilman@linaro.org>
| * ARM: shmobile: lager: do not annotate gpio_buttons as __initdataSimon Horman2013-07-311-1/+1
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | When the gpio-keys device is registered using platform_device_register_data() the platform data argument, lager_keys_pdata is duplicated and thus should be marked as __initdata to avoid wasting memory. However, this is not true of gpio_buttons, a reference to it rather than its value is duplicated when lager_keys_pdata is duplicated. This avoids accessing freed memory if gpio-key events occur after unused kernel memory is freed late in the kernel's boot. This but was added when support for gpio-keys was added to lager in c3842e4fcbb7664276443b79187b7808c2e80a35 ("ARM: shmobile: lager: support GPIO switches") which was included in v3.11-rc1. Tested-by: Magnus Damm <damm@opensource.se> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* | ARM: shmobile: Make r8a7790 Arch timer optionalMagnus Damm2013-07-171-0/+1
| | | | | | | | | | | | | | | | Update the r8a7790 code to allow using other timers than Arch timer for clock events. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* | ARM: shmobile: lager: Remove init_irq declaration in machine descriptionMagnus Damm2013-07-171-2/+0
|/ | | | | | | | | | | Remove redundant irqchip_init() callback. The default case of NULL will result in invoking irqchip_init() anyway. Signed-off-by: Magnus Damm <damm@opensource.se> [ horms+renesas@verge.net.au: Trimmed patch to remove portion that updates the r8a7790 SoC and altered the subject to use the same format as the patch that updates the r8a7790. ] Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: lager: support GPIO switchesSimon Horman2013-06-071-1/+23
| | | | | | | | The lager board has pins 1 - 4 of SW2 wired up to GPIO pins. This patch allows access to those pins as KEYS 1 - 4 using gpio-keys. Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: lager: Add GPIO LEDsSimon Horman2013-06-071-0/+27
| | | | | | | | | | The board has 3 LEDs connected to GPIOs. Add a led-gpio device to support them. Based on "ARM: shmobile: marzen: Add GPIO LEDs" by Laurent Pinchart. Cc: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: lager: Initialize pinmuxLaurent Pinchart2013-06-051-0/+15
| | | | | | | | Initialize r8a7790 pinmuxing and register mappings for the two debug serial ports. Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: use r8a7790 timer setup code on LagerMagnus Damm2013-04-091-1/+1
| | | | | | | | | | Use the r8a7790 timer init function on Lager to make sure the architected timer is started regardless of boot loader setting. Signed-off-by: Magnus Damm <damm@opensource.se> Tested-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
* ARM: shmobile: Initial r8a7790 Lager board supportMagnus Damm2013-04-031-0/+46
Lager base board support making use of 2 GiB of memory, the r8a7790 SoC with the SCIF0 serial port and CA15 with ARM architected timer. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
generated by cgit v1.1 at 2025-02-05 14:34:10 +0000