ARM: OMAP: switch to gpio_direction_output

More conversion to the standard GPIO interfaces:  stop using
omap_set_gpio_direction() entirely, and switch over to the
gpio_direction_output() call.

Note that because gpio_direction_output() includes the initial
value, this change isn't quite transparent.

 - For the call sites which defined an initial value either
   before or after setting the direction, that value was used.

   When that value was previously assigned afterwards, this
   could eliminate a brief output glitch ... and possibly
   change behavior.  In a few cases (LCDs) several values
   were assigned together ... those were re-arranged to match
   the explicit sequence provided.

 - Some call sites didn't define such a value; so I chose an
   initial "off/reset" value that seemed to default to "off".

In short, files touched by this patch might notice some small
changes in startup behavior (with trivial fixes).

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Tony Lindgren <tony@atomide.com>

1 files changed, 1 insertions, 2 deletions

diff --git a/arch/arm/mach-omap1/board-palmz71.c b/arch/arm/mach-omap1/board-palmz71.c
index 5a232ad..dec2010 100644
--- a/arch/arm/mach-omap1/board-palmz71.c
+++ b/arch/arm/mach-omap1/board-palmz71.c
@@ -323,8 +323,7 @@ palmz71_gpio_setup(int early)
 {
 	if (early) {
 		/* Only set GPIO1 so we have a working serial */
-		gpio_set_value(1, 1);
-		omap_set_gpio_direction(1, 0);
+		gpio_direction_output(1, 1);
 	} else {
 		/* Set MMC/SD host WP pin as input */
 		if (omap_request_gpio(PALMZ71_MMC_WP_GPIO)) {