diff options
Diffstat (limited to 'drivers/pci/hotplug/cpqphp_ctrl.c')
| -rw-r--r-- | drivers/pci/hotplug/cpqphp_ctrl.c | 27 |
1 files changed, 15 insertions, 12 deletions
diff --git a/drivers/pci/hotplug/cpqphp_ctrl.c b/drivers/pci/hotplug/cpqphp_ctrl.c index 0ff689a..e43908d 100644 --- a/drivers/pci/hotplug/cpqphp_ctrl.c +++ b/drivers/pci/hotplug/cpqphp_ctrl.c @@ -1130,12 +1130,13 @@ static int is_bridge(struct pci_func * func) static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_slot) { struct slot *slot; + struct pci_bus *bus = ctrl->pci_bus; u8 reg; u8 slot_power = readb(ctrl->hpc_reg + SLOT_POWER); u16 reg16; u32 leds = readl(ctrl->hpc_reg + LED_CONTROL); - if (ctrl->speed == adapter_speed) + if (bus->cur_bus_speed == adapter_speed) return 0; /* We don't allow freq/mode changes if we find another adapter running @@ -1152,7 +1153,7 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ * lower speed/mode, we allow the new adapter to function at * this rate if supported */ - if (ctrl->speed < adapter_speed) + if (bus->cur_bus_speed < adapter_speed) return 0; return 1; @@ -1161,20 +1162,20 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ /* If the controller doesn't support freq/mode changes and the * controller is running at a higher mode, we bail */ - if ((ctrl->speed > adapter_speed) && (!ctrl->pcix_speed_capability)) + if ((bus->cur_bus_speed > adapter_speed) && (!ctrl->pcix_speed_capability)) return 1; /* But we allow the adapter to run at a lower rate if possible */ - if ((ctrl->speed < adapter_speed) && (!ctrl->pcix_speed_capability)) + if ((bus->cur_bus_speed < adapter_speed) && (!ctrl->pcix_speed_capability)) return 0; /* We try to set the max speed supported by both the adapter and * controller */ - if (ctrl->speed_capability < adapter_speed) { - if (ctrl->speed == ctrl->speed_capability) + if (bus->max_bus_speed < adapter_speed) { + if (bus->cur_bus_speed == bus->max_bus_speed) return 0; - adapter_speed = ctrl->speed_capability; + adapter_speed = bus->max_bus_speed; } writel(0x0L, ctrl->hpc_reg + LED_CONTROL); @@ -1229,8 +1230,8 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ pci_write_config_byte(ctrl->pci_dev, 0x43, reg); /* Only if mode change...*/ - if (((ctrl->speed == PCI_SPEED_66MHz) && (adapter_speed == PCI_SPEED_66MHz_PCIX)) || - ((ctrl->speed == PCI_SPEED_66MHz_PCIX) && (adapter_speed == PCI_SPEED_66MHz))) + if (((bus->cur_bus_speed == PCI_SPEED_66MHz) && (adapter_speed == PCI_SPEED_66MHz_PCIX)) || + ((bus->cur_bus_speed == PCI_SPEED_66MHz_PCIX) && (adapter_speed == PCI_SPEED_66MHz))) set_SOGO(ctrl); wait_for_ctrl_irq(ctrl); @@ -1243,7 +1244,7 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ set_SOGO(ctrl); wait_for_ctrl_irq(ctrl); - ctrl->speed = adapter_speed; + bus->cur_bus_speed = adapter_speed; slot = cpqhp_find_slot(ctrl, hp_slot + ctrl->slot_device_offset); info("Successfully changed frequency/mode for adapter in slot %d\n", @@ -1269,6 +1270,7 @@ static u8 set_controller_speed(struct controller *ctrl, u8 adapter_speed, u8 hp_ */ static u32 board_replaced(struct pci_func *func, struct controller *ctrl) { + struct pci_bus *bus = ctrl->pci_bus; u8 hp_slot; u8 temp_byte; u8 adapter_speed; @@ -1309,7 +1311,7 @@ static u32 board_replaced(struct pci_func *func, struct controller *ctrl) wait_for_ctrl_irq (ctrl); adapter_speed = get_adapter_speed(ctrl, hp_slot); - if (ctrl->speed != adapter_speed) + if (bus->cur_bus_speed != adapter_speed) if (set_controller_speed(ctrl, adapter_speed, hp_slot)) rc = WRONG_BUS_FREQUENCY; @@ -1426,6 +1428,7 @@ static u32 board_added(struct pci_func *func, struct controller *ctrl) u32 temp_register = 0xFFFFFFFF; u32 rc = 0; struct pci_func *new_slot = NULL; + struct pci_bus *bus = ctrl->pci_bus; struct slot *p_slot; struct resource_lists res_lists; @@ -1456,7 +1459,7 @@ static u32 board_added(struct pci_func *func, struct controller *ctrl) wait_for_ctrl_irq (ctrl); adapter_speed = get_adapter_speed(ctrl, hp_slot); - if (ctrl->speed != adapter_speed) + if (bus->cur_bus_speed != adapter_speed) if (set_controller_speed(ctrl, adapter_speed, hp_slot)) rc = WRONG_BUS_FREQUENCY; |