diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 39 |
1 files changed, 39 insertions, 0 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index fe1a3a6..7f256e2 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -1271,6 +1271,15 @@ ieee80211_get_alt_retry_rate(const struct ieee80211_hw *hw, * dynamic PS feature in stack and will just keep %IEEE80211_CONF_PS * enabled whenever user has enabled powersave. * + * Some hardware need to toggle a single shared antenna between WLAN and + * Bluetooth to facilitate co-existence. These types of hardware set + * limitations on the use of host controlled dynamic powersave whenever there + * is simultaneous WLAN and Bluetooth traffic. For these types of hardware, the + * driver may request temporarily going into full power save, in order to + * enable toggling the antenna between BT and WLAN. If the driver requests + * disabling dynamic powersave, the @dynamic_ps_timeout value will be + * temporarily set to zero until the driver re-enables dynamic powersave. + * * Driver informs U-APSD client support by enabling * %IEEE80211_HW_SUPPORTS_UAPSD flag. The mode is configured through the * uapsd paramater in conf_tx() operation. Hardware needs to send the QoS @@ -2447,6 +2456,36 @@ void ieee80211_beacon_loss(struct ieee80211_vif *vif); void ieee80211_connection_loss(struct ieee80211_vif *vif); /** + * ieee80211_disable_dyn_ps - force mac80211 to temporarily disable dynamic psm + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * + * Some hardware require full power save to manage simultaneous BT traffic + * on the WLAN frequency. Full PSM is required periodically, whenever there are + * burst of BT traffic. The hardware gets information of BT traffic via + * hardware co-existence lines, and consequentially requests mac80211 to + * (temporarily) enter full psm. + * This function will only temporarily disable dynamic PS, not enable PSM if + * it was not already enabled. + * The driver must make sure to re-enable dynamic PS using + * ieee80211_enable_dyn_ps() if the driver has disabled it. + * + */ +void ieee80211_disable_dyn_ps(struct ieee80211_vif *vif); + +/** + * ieee80211_enable_dyn_ps - restore dynamic psm after being disabled + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * + * This function restores dynamic PS after being temporarily disabled via + * ieee80211_disable_dyn_ps(). Each ieee80211_disable_dyn_ps() call must + * be coupled with an eventual call to this function. + * + */ +void ieee80211_enable_dyn_ps(struct ieee80211_vif *vif); + +/** * ieee80211_cqm_rssi_notify - inform a configured connection quality monitoring * rssi threshold triggered * |