diff options
author | Shen Feng <shen@cn.fujitsu.com> | 2009-04-02 16:57:20 -0700 |
---|---|---|
committer | Linus Torvalds <torvalds@linux-foundation.org> | 2009-04-02 19:04:53 -0700 |
commit | 760df93ecdd59fc1c213a491b5adee79f53606da (patch) | |
tree | 305a4e0fae43549eb24a3ebcf9bcc15a16ef2138 /Documentation/sysctl/net.txt | |
parent | 70eed8d06601ca3810a0e56035eae6496d57856b (diff) | |
download | kernel_samsung_espresso10-760df93ecdd59fc1c213a491b5adee79f53606da.zip kernel_samsung_espresso10-760df93ecdd59fc1c213a491b5adee79f53606da.tar.gz kernel_samsung_espresso10-760df93ecdd59fc1c213a491b5adee79f53606da.tar.bz2 |
documentation: update Documentation/filesystem/proc.txt and Documentation/sysctls
Now /proc/sys is described in many places and much information is
redundant. This patch updates the proc.txt and move the /proc/sys
desciption out to the files in Documentation/sysctls.
Details are:
merge
- 2.1 /proc/sys/fs - File system data
- 2.11 /proc/sys/fs/mqueue - POSIX message queues filesystem
- 2.17 /proc/sys/fs/epoll - Configuration options for the epoll interface
with Documentation/sysctls/fs.txt.
remove
- 2.2 /proc/sys/fs/binfmt_misc - Miscellaneous binary formats
since it's not better then the Documentation/binfmt_misc.txt.
merge
- 2.3 /proc/sys/kernel - general kernel parameters
with Documentation/sysctls/kernel.txt
remove
- 2.5 /proc/sys/dev - Device specific parameters
since it's obsolete the sysfs is used now.
remove
- 2.6 /proc/sys/sunrpc - Remote procedure calls
since it's not better then the Documentation/sysctls/sunrpc.txt
move
- 2.7 /proc/sys/net - Networking stuff
- 2.9 Appletalk
- 2.10 IPX
to newly created Documentation/sysctls/net.txt.
remove
- 2.8 /proc/sys/net/ipv4 - IPV4 settings
since it's not better then the Documentation/networking/ip-sysctl.txt.
add
- Chapter 3 Per-Process Parameters
to descibe /proc/<pid>/xxx parameters.
Signed-off-by: Shen Feng <shen@cn.fujitsu.com>
Cc: Randy Dunlap <randy.dunlap@oracle.com>
Cc: "David S. Miller" <davem@davemloft.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Diffstat (limited to 'Documentation/sysctl/net.txt')
-rw-r--r-- | Documentation/sysctl/net.txt | 174 |
1 files changed, 174 insertions, 0 deletions
diff --git a/Documentation/sysctl/net.txt b/Documentation/sysctl/net.txt new file mode 100644 index 0000000..995c225 --- /dev/null +++ b/Documentation/sysctl/net.txt @@ -0,0 +1,174 @@ +Documentation for /proc/sys/net/* kernel version 2.4.0-test11-pre4 + (c) 1999 Terrehon Bowden <terrehon@pacbell.net> + Bodo Bauer <bb@ricochet.net> + (c) 2000 Jorge Nerin <comandante@zaralinux.com> + (c) 2009 Shen Feng <shen@cn.fujitsu.com> + +For general info and legal blurb, please look in README. + +============================================================== + +This file contains the documentation for the sysctl files in +/proc/sys/net and is valid for Linux kernel version 2.4.0-test11-pre4. + +The interface to the networking parts of the kernel is located in +/proc/sys/net. The following table shows all possible subdirectories.You may +see only some of them, depending on your kernel's configuration. + + +Table : Subdirectories in /proc/sys/net +.............................................................................. + Directory Content Directory Content + core General parameter appletalk Appletalk protocol + unix Unix domain sockets netrom NET/ROM + 802 E802 protocol ax25 AX25 + ethernet Ethernet protocol rose X.25 PLP layer + ipv4 IP version 4 x25 X.25 protocol + ipx IPX token-ring IBM token ring + bridge Bridging decnet DEC net + ipv6 IP version 6 +.............................................................................. + +1. /proc/sys/net/core - Network core options +------------------------------------------------------- + +rmem_default +------------ + +The default setting of the socket receive buffer in bytes. + +rmem_max +-------- + +The maximum receive socket buffer size in bytes. + +wmem_default +------------ + +The default setting (in bytes) of the socket send buffer. + +wmem_max +-------- + +The maximum send socket buffer size in bytes. + +message_burst and message_cost +------------------------------ + +These parameters are used to limit the warning messages written to the kernel +log from the networking code. They enforce a rate limit to make a +denial-of-service attack impossible. A higher message_cost factor, results in +fewer messages that will be written. Message_burst controls when messages will +be dropped. The default settings limit warning messages to one every five +seconds. + +warnings +-------- + +This controls console messages from the networking stack that can occur because +of problems on the network like duplicate address or bad checksums. Normally, +this should be enabled, but if the problem persists the messages can be +disabled. + +netdev_budget +------------- + +Maximum number of packets taken from all interfaces in one polling cycle (NAPI +poll). In one polling cycle interfaces which are registered to polling are +probed in a round-robin manner. The limit of packets in one such probe can be +set per-device via sysfs class/net/<device>/weight . + +netdev_max_backlog +------------------ + +Maximum number of packets, queued on the INPUT side, when the interface +receives packets faster than kernel can process them. + +optmem_max +---------- + +Maximum ancillary buffer size allowed per socket. Ancillary data is a sequence +of struct cmsghdr structures with appended data. + +2. /proc/sys/net/unix - Parameters for Unix domain sockets +------------------------------------------------------- + +There are only two files in this subdirectory. They control the delays for +deleting and destroying socket descriptors. + + +3. /proc/sys/net/ipv4 - IPV4 settings +------------------------------------------------------- +Please see: Documentation/networking/ip-sysctl.txt and ipvs-sysctl.txt for +descriptions of these entries. + + +4. Appletalk +------------------------------------------------------- + +The /proc/sys/net/appletalk directory holds the Appletalk configuration data +when Appletalk is loaded. The configurable parameters are: + +aarp-expiry-time +---------------- + +The amount of time we keep an ARP entry before expiring it. Used to age out +old hosts. + +aarp-resolve-time +----------------- + +The amount of time we will spend trying to resolve an Appletalk address. + +aarp-retransmit-limit +--------------------- + +The number of times we will retransmit a query before giving up. + +aarp-tick-time +-------------- + +Controls the rate at which expires are checked. + +The directory /proc/net/appletalk holds the list of active Appletalk sockets +on a machine. + +The fields indicate the DDP type, the local address (in network:node format) +the remote address, the size of the transmit pending queue, the size of the +received queue (bytes waiting for applications to read) the state and the uid +owning the socket. + +/proc/net/atalk_iface lists all the interfaces configured for appletalk.It +shows the name of the interface, its Appletalk address, the network range on +that address (or network number for phase 1 networks), and the status of the +interface. + +/proc/net/atalk_route lists each known network route. It lists the target +(network) that the route leads to, the router (may be directly connected), the +route flags, and the device the route is using. + + +5. IPX +------------------------------------------------------- + +The IPX protocol has no tunable values in proc/sys/net. + +The IPX protocol does, however, provide proc/net/ipx. This lists each IPX +socket giving the local and remote addresses in Novell format (that is +network:node:port). In accordance with the strange Novell tradition, +everything but the port is in hex. Not_Connected is displayed for sockets that +are not tied to a specific remote address. The Tx and Rx queue sizes indicate +the number of bytes pending for transmission and reception. The state +indicates the state the socket is in and the uid is the owning uid of the +socket. + +The /proc/net/ipx_interface file lists all IPX interfaces. For each interface +it gives the network number, the node number, and indicates if the network is +the primary network. It also indicates which device it is bound to (or +Internal for internal networks) and the Frame Type if appropriate. Linux +supports 802.3, 802.2, 802.2 SNAP and DIX (Blue Book) ethernet framing for +IPX. + +The /proc/net/ipx_route table holds a list of IPX routes. For each route it +gives the destination network, the router node (or Directly) and the network +address of the router (or Connected) for internal networks. |