1 files changed, 8 insertions, 89 deletions
diff --git a/include/asm-sparc/auxio.h b/include/asm-sparc/auxio.h
index e552b8d..24c6f3c 100644
--- a/include/asm-sparc/auxio.h
+++ b/include/asm-sparc/auxio.h
@@ -1,89 +1,8 @@
-/*
- * auxio.h:  Definitions and code for the Auxiliary I/O register.
- *
- * Copyright (C) 1995 David S. Miller (davem@caip.rutgers.edu)
- */
-#ifndef _SPARC_AUXIO_H
-#define _SPARC_AUXIO_H
-
-#include <asm/system.h>
-#include <asm/vaddrs.h>
-
-/* This register is an unsigned char in IO space.  It does two things.
- * First, it is used to control the front panel LED light on machines
- * that have it (good for testing entry points to trap handlers and irq's)
- * Secondly, it controls various floppy drive parameters.
- */
-#define AUXIO_ORMEIN      0xf0    /* All writes must set these bits. */
-#define AUXIO_ORMEIN4M    0xc0    /* sun4m - All writes must set these bits. */
-#define AUXIO_FLPY_DENS   0x20    /* Floppy density, high if set. Read only. */
-#define AUXIO_FLPY_DCHG   0x10    /* A disk change occurred.  Read only. */
-#define AUXIO_EDGE_ON     0x10    /* sun4m - On means Jumper block is in. */
-#define AUXIO_FLPY_DSEL   0x08    /* Drive select/start-motor. Write only. */
-#define AUXIO_LINK_TEST   0x08    /* sun4m - On means TPE Carrier detect. */
-
-/* Set the following to one, then zero, after doing a pseudo DMA transfer. */
-#define AUXIO_FLPY_TCNT   0x04    /* Floppy terminal count. Write only. */
-
-/* Set the following to zero to eject the floppy. */
-#define AUXIO_FLPY_EJCT   0x02    /* Eject floppy disk.  Write only. */
-#define AUXIO_LED         0x01    /* On if set, off if unset. Read/Write */
-
-#ifndef __ASSEMBLY__
-
-/* 
- * NOTE: these routines are implementation dependent-- 
- * understand the hardware you are querying! 
- */
-extern void set_auxio(unsigned char bits_on, unsigned char bits_off);
-extern unsigned char get_auxio(void); /* .../asm-sparc/floppy.h */
-
-/*
- * The following routines are provided for driver-compatibility
- * with sparc64 (primarily sunlance.c)
- */
-
-#define AUXIO_LTE_ON    1
-#define AUXIO_LTE_OFF   0
-
-/* auxio_set_lte - Set Link Test Enable (TPE Link Detect)
- *
- * on - AUXIO_LTE_ON or AUXIO_LTE_OFF
- */
-#define auxio_set_lte(on) \
-do { \
-	if(on) { \
-		set_auxio(AUXIO_LINK_TEST, 0); \
-	} else { \
-		set_auxio(0, AUXIO_LINK_TEST); \
-	} \
-} while (0)
-
-#define AUXIO_LED_ON    1
-#define AUXIO_LED_OFF   0
-
-/* auxio_set_led - Set system front panel LED
- *
- * on - AUXIO_LED_ON or AUXIO_LED_OFF
- */
-#define auxio_set_led(on) \
-do { \
-	if(on) { \
-		set_auxio(AUXIO_LED, 0); \
-	} else { \
-		set_auxio(0, AUXIO_LED); \
-	} \
-} while (0)
-
-#endif /* !(__ASSEMBLY__) */
-
-
-/* AUXIO2 (Power Off Control) */
-extern __volatile__ unsigned char * auxio_power_register;
-
-#define	AUXIO_POWER_DETECT_FAILURE	32
-#define	AUXIO_POWER_CLEAR_FAILURE	2
-#define	AUXIO_POWER_OFF			1
-
-
-#endif /* !(_SPARC_AUXIO_H) */
+#ifndef ___ASM_SPARC_AUXIO_H
+#define ___ASM_SPARC_AUXIO_H
+#if defined(__sparc__) && defined(__arch64__)
+#include <asm-sparc/auxio_64.h>
+#else
+#include <asm-sparc/auxio_32.h>
+#endif
+#endif