[SCSI] mpt2sas: Hold Controller reset when another reset is in progress

Driver should not allow multiple host reset when already host reset is in
progress. It is possible that host reset was sent by scsi mid layer while there was already an host reset active,
either issued via IOCTL interface or internaly, like a config page timeout.
Since there was a host reset active, the driver would return a FAILED response
to the scsi mid layer. The solution is make sure pending host resets will
wait for the active host reset to complete before returning control
back up the call stack.

Signed-off-by: Kashyap Desai <kashyap.desai@lsi.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>

1 files changed, 4 insertions, 0 deletions

diff --git a/drivers/scsi/mpt2sas/mpt2sas_base.h b/drivers/scsi/mpt2sas/mpt2sas_base.h
index 0f41fcd..6032cbf 100644
--- a/drivers/scsi/mpt2sas/mpt2sas_base.h
+++ b/drivers/scsi/mpt2sas/mpt2sas_base.h
@@ -600,9 +600,13 @@ struct MPT2SAS_ADAPTER {
 	int		aen_event_read_flag;
 	u8		broadcast_aen_busy;
 	u8		shost_recovery;
+
+	struct mutex	reset_in_progress_mutex;
 	struct completion	shost_recovery_done;
 	spinlock_t 	ioc_reset_in_progress_lock;
 	u8		ioc_link_reset_in_progress;
+	int		ioc_reset_in_progress_status;
+
 	u8		ignore_loginfos;
 	u8		remove_host;
 	u8		wait_for_port_enable_to_complete;