diff options
-rw-r--r-- | arch/x86_64/kernel/apic.c | 92 | ||||
-rw-r--r-- | arch/x86_64/kernel/mpparse.c | 8 | ||||
-rw-r--r-- | arch/x86_64/kernel/smpboot.c | 1 | ||||
-rw-r--r-- | include/asm-x86_64/mpspec.h | 1 | ||||
-rw-r--r-- | include/asm-x86_64/smp.h | 1 |
5 files changed, 29 insertions, 74 deletions
diff --git a/arch/x86_64/kernel/apic.c b/arch/x86_64/kernel/apic.c index 78c43b1..20a76f2 100644 --- a/arch/x86_64/kernel/apic.c +++ b/arch/x86_64/kernel/apic.c @@ -136,72 +136,40 @@ void clear_local_APIC(void) apic_read(APIC_ESR); } -void __init connect_bsp_APIC(void) -{ - if (pic_mode) { - /* - * Do not trust the local APIC being empty at bootup. - */ - clear_local_APIC(); - /* - * PIC mode, enable APIC mode in the IMCR, i.e. - * connect BSP's local APIC to INT and NMI lines. - */ - apic_printk(APIC_VERBOSE, "leaving PIC mode, enabling APIC mode.\n"); - outb(0x70, 0x22); - outb(0x01, 0x23); - } -} - void disconnect_bsp_APIC(int virt_wire_setup) { - if (pic_mode) { - /* - * Put the board back into PIC mode (has an effect - * only on certain older boards). Note that APIC - * interrupts, including IPIs, won't work beyond - * this point! The only exception are INIT IPIs. - */ - apic_printk(APIC_QUIET, "disabling APIC mode, entering PIC mode.\n"); - outb(0x70, 0x22); - outb(0x00, 0x23); - } - else { - /* Go back to Virtual Wire compatibility mode */ - unsigned long value; - - /* For the spurious interrupt use vector F, and enable it */ - value = apic_read(APIC_SPIV); - value &= ~APIC_VECTOR_MASK; - value |= APIC_SPIV_APIC_ENABLED; - value |= 0xf; - apic_write(APIC_SPIV, value); - - if (!virt_wire_setup) { - /* For LVT0 make it edge triggered, active high, external and enabled */ - value = apic_read(APIC_LVT0); - value &= ~(APIC_MODE_MASK | APIC_SEND_PENDING | - APIC_INPUT_POLARITY | APIC_LVT_REMOTE_IRR | - APIC_LVT_LEVEL_TRIGGER | APIC_LVT_MASKED ); - value |= APIC_LVT_REMOTE_IRR | APIC_SEND_PENDING; - value = SET_APIC_DELIVERY_MODE(value, APIC_MODE_EXTINT); - apic_write(APIC_LVT0, value); - } - else { - /* Disable LVT0 */ - apic_write(APIC_LVT0, APIC_LVT_MASKED); - } + /* Go back to Virtual Wire compatibility mode */ + unsigned long value; - /* For LVT1 make it edge triggered, active high, nmi and enabled */ - value = apic_read(APIC_LVT1); - value &= ~( - APIC_MODE_MASK | APIC_SEND_PENDING | + /* For the spurious interrupt use vector F, and enable it */ + value = apic_read(APIC_SPIV); + value &= ~APIC_VECTOR_MASK; + value |= APIC_SPIV_APIC_ENABLED; + value |= 0xf; + apic_write(APIC_SPIV, value); + + if (!virt_wire_setup) { + /* For LVT0 make it edge triggered, active high, external and enabled */ + value = apic_read(APIC_LVT0); + value &= ~(APIC_MODE_MASK | APIC_SEND_PENDING | APIC_INPUT_POLARITY | APIC_LVT_REMOTE_IRR | - APIC_LVT_LEVEL_TRIGGER | APIC_LVT_MASKED); + APIC_LVT_LEVEL_TRIGGER | APIC_LVT_MASKED ); value |= APIC_LVT_REMOTE_IRR | APIC_SEND_PENDING; - value = SET_APIC_DELIVERY_MODE(value, APIC_MODE_NMI); - apic_write(APIC_LVT1, value); + value = SET_APIC_DELIVERY_MODE(value, APIC_MODE_EXTINT); + apic_write(APIC_LVT0, value); + } else { + /* Disable LVT0 */ + apic_write(APIC_LVT0, APIC_LVT_MASKED); } + + /* For LVT1 make it edge triggered, active high, nmi and enabled */ + value = apic_read(APIC_LVT1); + value &= ~(APIC_MODE_MASK | APIC_SEND_PENDING | + APIC_INPUT_POLARITY | APIC_LVT_REMOTE_IRR | + APIC_LVT_LEVEL_TRIGGER | APIC_LVT_MASKED); + value |= APIC_LVT_REMOTE_IRR | APIC_SEND_PENDING; + value = SET_APIC_DELIVERY_MODE(value, APIC_MODE_NMI); + apic_write(APIC_LVT1, value); } void disable_local_APIC(void) @@ -418,7 +386,7 @@ void __cpuinit setup_local_APIC (void) * TODO: set up through-local-APIC from through-I/O-APIC? --macro */ value = apic_read(APIC_LVT0) & APIC_LVT_MASKED; - if (!smp_processor_id() && (pic_mode || !value)) { + if (!smp_processor_id() && !value) { value = APIC_DM_EXTINT; apic_printk(APIC_VERBOSE, "enabled ExtINT on CPU#%d\n", smp_processor_id()); } else { @@ -1096,8 +1064,6 @@ int __init APIC_init_uniprocessor (void) verify_local_APIC(); - connect_bsp_APIC(); - phys_cpu_present_map = physid_mask_of_physid(boot_cpu_id); apic_write(APIC_ID, SET_APIC_ID(boot_cpu_id)); diff --git a/arch/x86_64/kernel/mpparse.c b/arch/x86_64/kernel/mpparse.c index 90e99cf..0226245 100644 --- a/arch/x86_64/kernel/mpparse.c +++ b/arch/x86_64/kernel/mpparse.c @@ -56,7 +56,6 @@ struct mpc_config_intsrc mp_irqs[MAX_IRQ_SOURCES]; int mp_irq_entries; int nr_ioapics; -int pic_mode; unsigned long mp_lapic_addr = 0; @@ -514,13 +513,6 @@ void __init get_smp_config (void) printk(KERN_INFO "Using ACPI for processor (LAPIC) configuration information\n"); printk("Intel MultiProcessor Specification v1.%d\n", mpf->mpf_specification); - if (mpf->mpf_feature2 & (1<<7)) { - printk(KERN_INFO " IMCR and PIC compatibility mode.\n"); - pic_mode = 1; - } else { - printk(KERN_INFO " Virtual Wire compatibility mode.\n"); - pic_mode = 0; - } /* * Now see if we need to read further. diff --git a/arch/x86_64/kernel/smpboot.c b/arch/x86_64/kernel/smpboot.c index d29571e..ae7d6d8 100644 --- a/arch/x86_64/kernel/smpboot.c +++ b/arch/x86_64/kernel/smpboot.c @@ -1090,7 +1090,6 @@ void __init smp_prepare_cpus(unsigned int max_cpus) /* * Switch from PIC to APIC mode. */ - connect_bsp_APIC(); setup_local_APIC(); if (GET_APIC_ID(apic_read(APIC_ID)) != boot_cpu_id) { diff --git a/include/asm-x86_64/mpspec.h b/include/asm-x86_64/mpspec.h index 3c7aae9..1dc8343 100644 --- a/include/asm-x86_64/mpspec.h +++ b/include/asm-x86_64/mpspec.h @@ -178,7 +178,6 @@ extern int mp_irq_entries; extern struct mpc_config_intsrc mp_irqs [MAX_IRQ_SOURCES]; extern int mpc_default_type; extern unsigned long mp_lapic_addr; -extern int pic_mode; #ifdef CONFIG_ACPI extern void mp_register_lapic (u8 id, u8 enabled); diff --git a/include/asm-x86_64/smp.h b/include/asm-x86_64/smp.h index 6353fa4..498fbc1 100644 --- a/include/asm-x86_64/smp.h +++ b/include/asm-x86_64/smp.h @@ -33,7 +33,6 @@ extern cpumask_t cpu_initialized; extern void smp_alloc_memory(void); extern volatile unsigned long smp_invalidate_needed; -extern int pic_mode; extern void lock_ipi_call_lock(void); extern void unlock_ipi_call_lock(void); extern int smp_num_siblings; |