diff options
Diffstat (limited to 'arch/avr32/mach-at32ap/include/mach/board.h')
-rw-r--r-- | arch/avr32/mach-at32ap/include/mach/board.h | 121 |
1 files changed, 121 insertions, 0 deletions
diff --git a/arch/avr32/mach-at32ap/include/mach/board.h b/arch/avr32/mach-at32ap/include/mach/board.h new file mode 100644 index 0000000..e60e907 --- /dev/null +++ b/arch/avr32/mach-at32ap/include/mach/board.h @@ -0,0 +1,121 @@ +/* + * Platform data definitions. + */ +#ifndef __ASM_ARCH_BOARD_H +#define __ASM_ARCH_BOARD_H + +#include <linux/types.h> + +#define GPIO_PIN_NONE (-1) + +/* + * Clock rates for various on-board oscillators. The number of entries + * in this array is chip-dependent. + */ +extern unsigned long at32_board_osc_rates[]; + +/* Add basic devices: system manager, interrupt controller, portmuxes, etc. */ +void at32_add_system_devices(void); + +#define ATMEL_MAX_UART 4 +extern struct platform_device *atmel_default_console_device; + +struct atmel_uart_data { + short use_dma_tx; /* use transmit DMA? */ + short use_dma_rx; /* use receive DMA? */ + void __iomem *regs; /* virtual base address, if any */ +}; +void at32_map_usart(unsigned int hw_id, unsigned int line); +struct platform_device *at32_add_device_usart(unsigned int id); + +struct eth_platform_data { + u32 phy_mask; + u8 is_rmii; +}; +struct platform_device * +at32_add_device_eth(unsigned int id, struct eth_platform_data *data); + +struct spi_board_info; +struct platform_device * +at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n); + +struct atmel_lcdfb_info; +struct platform_device * +at32_add_device_lcdc(unsigned int id, struct atmel_lcdfb_info *data, + unsigned long fbmem_start, unsigned long fbmem_len, + unsigned int pin_config); + +struct usba_platform_data; +struct platform_device * +at32_add_device_usba(unsigned int id, struct usba_platform_data *data); + +struct ide_platform_data { + u8 cs; +}; +struct platform_device * +at32_add_device_ide(unsigned int id, unsigned int extint, + struct ide_platform_data *data); + +/* mask says which PWM channels to mux */ +struct platform_device *at32_add_device_pwm(u32 mask); + +/* depending on what's hooked up, not all SSC pins will be used */ +#define ATMEL_SSC_TK 0x01 +#define ATMEL_SSC_TF 0x02 +#define ATMEL_SSC_TD 0x04 +#define ATMEL_SSC_TX (ATMEL_SSC_TK | ATMEL_SSC_TF | ATMEL_SSC_TD) + +#define ATMEL_SSC_RK 0x10 +#define ATMEL_SSC_RF 0x20 +#define ATMEL_SSC_RD 0x40 +#define ATMEL_SSC_RX (ATMEL_SSC_RK | ATMEL_SSC_RF | ATMEL_SSC_RD) + +struct platform_device * +at32_add_device_ssc(unsigned int id, unsigned int flags); + +struct i2c_board_info; +struct platform_device *at32_add_device_twi(unsigned int id, + struct i2c_board_info *b, + unsigned int n); + +struct mci_platform_data; +struct platform_device * +at32_add_device_mci(unsigned int id, struct mci_platform_data *data); + +struct ac97c_platform_data { + unsigned short dma_rx_periph_id; + unsigned short dma_tx_periph_id; + unsigned short dma_controller_id; + int reset_pin; +}; +struct platform_device * +at32_add_device_ac97c(unsigned int id, struct ac97c_platform_data *data); + +struct platform_device *at32_add_device_abdac(unsigned int id); +struct platform_device *at32_add_device_psif(unsigned int id); + +struct cf_platform_data { + int detect_pin; + int reset_pin; + int vcc_pin; + int ready_pin; + u8 cs; +}; +struct platform_device * +at32_add_device_cf(unsigned int id, unsigned int extint, + struct cf_platform_data *data); + +/* NAND / SmartMedia */ +struct atmel_nand_data { + int enable_pin; /* chip enable */ + int det_pin; /* card detect */ + int rdy_pin; /* ready/busy */ + u8 ale; /* address line number connected to ALE */ + u8 cle; /* address line number connected to CLE */ + u8 bus_width_16; /* buswidth is 16 bit */ + struct mtd_partition *(*partition_info)(int size, int *num_partitions); +}; +struct platform_device * +at32_add_device_nand(unsigned int id, struct atmel_nand_data *data); + +#endif /* __ASM_ARCH_BOARD_H */ |