diff options
Diffstat (limited to 'drivers/i2c/busses/i2c-piix4.c')
| -rw-r--r-- | drivers/i2c/busses/i2c-piix4.c | 33 |
1 files changed, 8 insertions, 25 deletions
diff --git a/drivers/i2c/busses/i2c-piix4.c b/drivers/i2c/busses/i2c-piix4.c index d9c7c00..8f2f65b 100644 --- a/drivers/i2c/busses/i2c-piix4.c +++ b/drivers/i2c/busses/i2c-piix4.c @@ -102,13 +102,6 @@ MODULE_PARM_DESC(force_addr, "Forcibly enable the PIIX4 at the given address. " "EXTREMELY DANGEROUS!"); -/* If fix_hstcfg is set to anything different from 0, we reset one of the - registers to be a valid value. */ -static int fix_hstcfg; -module_param (fix_hstcfg, int, 0); -MODULE_PARM_DESC(fix_hstcfg, - "Fix config register. Needed on some boards (Force CPCI735)."); - static int piix4_transaction(void); static unsigned short piix4_smba; @@ -137,7 +130,7 @@ static int __devinit piix4_setup(struct pci_dev *PIIX4_dev, /* Don't access SMBus on IBM systems which get corrupted eeproms */ if (dmi_check_system(piix4_dmi_table) && PIIX4_dev->vendor == PCI_VENDOR_ID_INTEL) { - dev_err(&PIIX4_dev->dev, "IBM Laptop detected; this module " + dev_err(&PIIX4_dev->dev, "IBM system detected; this module " "may corrupt your serial eeprom! Refusing to load " "module!\n"); return -EPERM; @@ -166,22 +159,6 @@ static int __devinit piix4_setup(struct pci_dev *PIIX4_dev, pci_read_config_byte(PIIX4_dev, SMBHSTCFG, &temp); - /* Some BIOS will set up the chipset incorrectly and leave a register - in an undefined state (causing I2C to act very strangely). */ - if (temp & 0x02) { - if (fix_hstcfg) { - dev_info(&PIIX4_dev->dev, "Working around buggy BIOS " - "(I2C)\n"); - temp &= 0xfd; - pci_write_config_byte(PIIX4_dev, SMBHSTCFG, temp); - } else { - dev_info(&PIIX4_dev->dev, "Unusual config register " - "value\n"); - dev_info(&PIIX4_dev->dev, "Try using fix_hstcfg=1 if " - "you experience problems\n"); - } - } - /* If force_addr is set, we program the new address here. Just to make sure, we disable the PIIX4 first. */ if (force_addr) { @@ -214,7 +191,7 @@ static int __devinit piix4_setup(struct pci_dev *PIIX4_dev, } } - if ((temp & 0x0E) == 8) + if (((temp & 0x0E) == 8) || ((temp & 0x0E) == 2)) dev_dbg(&PIIX4_dev->dev, "Using Interrupt 9 for SMBus.\n"); else if ((temp & 0x0E) == 0) dev_dbg(&PIIX4_dev->dev, "Using Interrupt SMI# for SMBus.\n"); @@ -413,6 +390,12 @@ static struct i2c_adapter piix4_adapter = { static struct pci_device_id piix4_ids[] = { { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82371AB_3), .driver_data = 3 }, + { PCI_DEVICE(PCI_VENDOR_ID_ATI, PCI_DEVICE_ID_ATI_IXP200_SMBUS), + .driver_data = 0 }, + { PCI_DEVICE(PCI_VENDOR_ID_ATI, PCI_DEVICE_ID_ATI_IXP300_SMBUS), + .driver_data = 0 }, + { PCI_DEVICE(PCI_VENDOR_ID_ATI, PCI_DEVICE_ID_ATI_IXP400_SMBUS), + .driver_data = 0 }, { PCI_DEVICE(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_OSB4), .driver_data = 0 }, { PCI_DEVICE(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5), |