wimax/i2400m: clarify and fix i2400m->{ready,updown}

The i2400m driver uses two different bits to distinguish how much the
driver is up. i2400m->ready is used to denote that the infrastructure
to communicate with the device is up and running. i2400m->updown is
used to indicate if 'ready' and the device is up and running, ready to
take control and data traffic.

However, all this was pretty dirty and not clear, with many open spots
where race conditions were present.

This commit cleans up the situation by:

 - documenting the usage of both bits

 - setting them only in specific, well controlled places
   (i2400m_dev_start, i2400m_dev_stop)

 - ensuring the i2400m workqueue can't get in the middle of the
   setting by flushing it when i2400m->ready is set to zero. This
   allows the report hook not having to check again for the bit to be
   set [rx.c:i2400m_report_hook_work()].

 - using i2400m->updown to determine if the device is up and running
   instead of the wimax state in i2400m_dev_reset_handle().

 - not loosing missed messages sent by the hardware before
   i2400m->ready is set. In rx.c, whatever the device sends can be
   sent to user space over the message pipes as soon as the wimax
   device is registered, so don't wait for i2400m->ready to be set.

Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com>

1 files changed, 6 insertions, 0 deletions

diff --git a/include/net/wimax.h b/include/net/wimax.h
index 2af7bf8..d69c4a7 100644
--- a/include/net/wimax.h
+++ b/include/net/wimax.h
@@ -195,6 +195,12 @@
  *    defining the `struct nla_policy` for each message, it has to have
  *    an array size of WIMAX_GNL_ATTR_MAX+1.
  *
+ * The op_*() function pointers will not be called if the wimax_dev is
+ * in a state <= %WIMAX_ST_UNINITIALIZED. The exception is:
+ *
+ * - op_reset: can be called at any time after wimax_dev_add() has
+ *   been called.
+ *
  * THE PIPE INTERFACE:
  *
  * This interface is kept intentionally simple. The driver can send