1 files changed, 0 insertions, 53 deletions
diff --git a/qt602240_ts_input.idc b/qt602240_ts_input.idc
deleted file mode 100644
index bed1e8a..0000000
--- a/qt602240_ts_input.idc
+++ /dev/null
@@ -1,53 +0,0 @@
-# Copyright (C) 2010 The Android Open Source Project
-#
-# Licensed under the Apache License, Version 2.0 (the "License");
-# you may not use this file except in compliance with the License.
-# You may obtain a copy of the License at
-#
-#      http://www.apache.org/licenses/LICENSE-2.0
-#
-# Unless required by applicable law or agreed to in writing, software
-# distributed under the License is distributed on an "AS IS" BASIS,
-# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-# See the License for the specific language governing permissions and
-# limitations under the License.
-
-#
-# Input Device Calibration File
-#
-
-# Touch Area
-touch.touchArea.calibration = pressure
-
-# Tool Area
-#   Raw width field measures approx. 0.5 units per millimeter
-#   of tool area on the surface where a raw width of 15 corresponds
-#   to about 18mm of physical size.  Given that the display resolution
-#   is 9.6px per mm we obtain a scale factor of 4.8 pixels / unit and
-#   a bias of 100.8 pixels.  Each contact point is measured independently
-#   so the raw width is not a sum.
-touch.toolArea.calibration = linear
-touch.toolArea.linearScale = 4.8
-touch.toolArea.linearBias = 100.8
-touch.toolArea.isSummed = 0
-
-# Pressure
-#   Driver reports signal strength as pressure.
-#   A normal thumb touch while touching the back of the device
-#   typically registers about 40 signal strength units although
-#   this value is highly variable and is sensitive to contact area,
-#   manner of contact and environmental conditions.  We set the
-#   scale so that a normal touch with good signal strength will be
-#   reported as having a pressure somewhere in the vicinity of 1.0,
-#   a featherlight touch will be below 1.0 and a heavy or large touch
-#   will be above 1.0.  We don't expect these values to be accurate.
-touch.pressure.calibration = amplitude
-touch.pressure.source = default
-touch.pressure.scale = 0.025
-
-# Size
-touch.size.calibration = normalized
-
-# Orientation
-touch.orientation.calibration = none
-